MC68HC908RK2 Datasheet, PDF (96/232 Pages) Motorola, Inc – Microcontroller Unit

System Integration Module (SIM)
6.7.2 Stop Mode
In stop mode, the SIM counter is reset and the system clocks are
disabled. An interrupt request from a module can cause an exit from stop
mode. Stacking for interrupts begins after the selected stop recovery
time has elapsed. Reset or break also causes an exit from stop mode.
The SIM disables the clock generator module outputs (CGMOUT and
CGMXCLK) in stop mode, stopping the CPU and peripherals. Stop
recovery time is selectable using the SSREC bit in the CONFIG register.
If SSREC is set, stop recovery is reduced from the normal delay of 4096
CGMXCLK cycles down to 32. This is ideal for applications using canned
oscillators that do not require long startup times from stop mode.
NOTE: External crystal applications should use the full stop recovery time by
clearing the SSREC bit.
A break interrupt during stop mode sets the SIM break stop/wait bit
(SBSW) in the SIM break status register (SBSR).
The SIM counter is held in reset from the execution of the STOP
instruction until the beginning of stop recovery. It is then used to time the
recovery period. Figure 6-15 shows stop mode entry timing.
CPUSTOP
IAB
STOP ADDR
STOP ADDR + 1
SAME
SAME
IDB
PREVIOUS DATA
NEXT OPCODE
SAME
SAME
R/W
Note: Previous data can be operand data or the STOP opcode, depending on the last
instruction.
Figure 6-15. Stop Mode Entry Timing
CGMXCLK
INT/BREAK
IAB
STOP RECOVERY PERIOD
STOP +1
STOP + 2 STOP + 2
SP
SP – 1
SP – 2
SP – 3
Figure 6-16. Stop Mode Recovery from Interrupt or Break
Advance Information
96
System Integration Module (SIM)
MC68HC908RK2 — Rev. 4.0
MOTOROLA