MC68HC908RK2 Datasheet, PDF (119/232 Pages) Motorola, Inc – Microcontroller Unit

Internal Clock Generator Module (ICG)
Functional Description
8.4.4.2 Internal Clock Activity Detector
The internal clock activity detector looks for at least one falling edge on
the low-frequency base clock (IBASE) every time the external reference
(EREF) is low. Since EREF is less than half the frequency of IBASE, this
should occur every time. If it does not occur two consecutive times, the
internal clock inactivity indicator (IOFF) is set. IOFF will be cleared the
next time there is a falling edge of IBASE while EREF is low.
The internal clock stable bit (ICGS) is set when IBASE is within
approximately 5 percent of the target 307.2 kHz ±25 percent for two
consecutive measurements. ICGS is cleared when IBASE is outside the
5 percent of the target 307.2 kHz ±25 percent, the internal clock
generator is disabled (ICGEN is clear), or when IOFF is set.
8.4.4.3 External Clock Activity Detector
The external clock activity detector looks for at least one falling edge on
the external clock (ECLK) every time the internal reference (IREF) is low.
Since IREF is less than half the frequency of ECLK, this should occur
every time. If it does not occur two consecutive times, the external clock
inactivity indicator (EOFF) is set. EOFF will be cleared the next time
there is a falling edge of ECLK while IREF is low.
The external clock stable bit (ECGS) is also generated in the external
clock activity detector. ECGS is set on a falling edge of the external
stabilization clock (ESTBCLK). This will be 4096 ECLK cycles after the
external clock generator on bit (ECGON) is set. ECGS is cleared when
the external clock generator is disabled (ECGON is clear) or when EOFF
is set.
MC68HC908RK2 — Rev. 4.0
MOTOROLA
Internal Clock Generator Module (ICG)
Advance Information
119