English
Language : 

MC68HC705P6A Datasheet, PDF (35/130 Pages) Motorola, Inc – HCMOS Microcontroller Unit
Advance Information — MC68HC705P6A
Section 3. Operating Modes
3.1 Contents
3.2 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35
3.3 User Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36
3.4 Bootloader Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
3.5 Low-Power Modes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
3.5.1 STOP Instruction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .37
3.5.1.1 Stop Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
3.5.1.2 Halt Mode. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39
3.5.2 WAIT Instruction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .40
3.6 COP Watchdog Timer Considerations . . . . . . . . . . . . . . . . . . .40
3.2 Introduction
The MC68HC705P6A has two modes of operation that affect the pinout
and architecture of the MCU: user mode and bootloader mode. The user
mode is normally used for the application and the bootloader mode is
used for programming the EPROM. The conditions required to enter
each mode are shown in Table 3-1. The mode of operation is
determined by the voltages on the IRQ/VPP and PD7/TCAP pins on the
rising edge of the external RESET pin.
Table 3-1. Operating Mode Conditions After Reset
RESET Pin
IRQ/VPP
PD7/TCAP
Mode
VSS to VDD
VSS to VDD
Single chip
VPP
VDD
Bootloader
MC68HC705P6A — Rev. 2.0
MOTOROLA
Operating Modes
Advance Information
35