English
Language : 

MC68HC705P6A Datasheet, PDF (24/130 Pages) Motorola, Inc – HCMOS Microcontroller Unit
General Description
1.4.2.3 External Clock
An external clock from another CMOS-compatible device can be
connected to the OSC1 input, with the OSC2 input not connected, as
shown in Figure 1-2(b).
1.4.3 RESET
Driving this input low will reset the MCU to a known startup state. The
RESET pin contains an internal Schmitt trigger to improve its noise
immunity. Refer to Section 4. Resets.
1.4.4 PA0–PA7
These eight I/O pins comprise port A. The state of any pin is software
programmable and all port A lines are configured as inputs during
power-on or reset. Port A has mask-option register enabled interrupt
capability with internal pullup devices selectable for any pin. Refer to
Section 6. Input/Output Ports.
1.4.5 PB5/SDO, PB6/SDI, and PB7/SCK
These three I/O pins comprise port B and are shared with the SIOP
communications subsystem. The state of any pin is software
programmable, and all port B lines are configured as inputs during
power-on or reset. Refer to Section 6. Input/Output Ports and
Section 7. Serial Input/Output Port (SIOP).
1.4.6 PC0-PC2, PC3/AD3, PC4/AD2, PC5/AD1, PC6/AD0, and PC7/VREFH
These eight I/O pins comprise port C and are shared with the A/D
converter subsystem. The state of any pin is software programmable
and all port C lines are configured as inputs during power-on or reset.
Refer to Section 6. Input/Output Ports and Section 9. Analog
Subsystem.
Advance Information
24
General Description
MC68HC705P6A — Rev. 2.0
MOTOROLA