PIC24FV16KM204 Datasheet, PDF (78/336 Pages) Microchip Technology – General Purpose, 16-Bit Flash Microcontroller with XLP Technology Data Sheet

PIC24FV16KM204 FAMILY
6.4.3 READING THE DATA EEPROM
To read a word from data EEPROM, the Table Read
instruction is used. Since the EEPROM array is only
16 bits wide, only the TBLRDL instruction is needed.
The read operation is performed by loading TBLPAG
and WREG with the address of the EEPROM location,
followed by a TBLRDL instruction.
A typical read sequence, using the Table
Pointer management (builtin_tblpage and
builtin_tbloffset) and Table Read
(builtin_tblrdl) procedures from the C30
compiler library, is provided in Example 6-5.
Program Space Visibility (PSV) can also be used to
read locations in the data EEPROM.
EXAMPLE 6-5: READING THE DATA EEPROM USING THE TBLRD COMMAND
int __attribute__ ((space(eedata))) eeData = 0x1234;
int data;
// Data read from EEPROM
/*--------------------------------------------------------------------------------------------
The variable eeData must be a Global variable declared outside of any method
the code following this comment can be written inside the method that will execute the read
----------------------------------------------------------------------------------------------
*/
unsigned int offset;
// Set up a pointer to the EEPROM location to be erased
TBLPAG = __builtin_tblpage(&eeData);
// Initialize EE Data page pointer
offset = __builtin_tbloffset(&eeData);
// Initizlize lower word of address
data = __builtin_tblrdl(offset);
// Write EEPROM data to write latch
DS33030A-page 78
Advance Information
 2013 Microchip Technology Inc.