|
PIC18F2220_07 Datasheet, PDF (320/386 Pages) Microchip Technology – 28/40/44-Pin High-Performance, Enhanced Flash Microcontrollers with 10-Bit A/D and nanoWatt Technology | |||
|
◁ |
PIC18F2220/2320/4220/4320
TABLE 26-1: MEMORY PROGRAMMING REQUIREMENTS
DC Characteristics
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ⤠TA ⤠+85°C for industrial
-40°C ⤠TA ⤠+125°C for extended
Param
No.
Sym
Characteristic
Min Typâ Max Units
Conditions
Internal Program Memory
Programming Specifications
D110 VPP Voltage on MCLR/VPP pin
9.00
â 13.25 V (Note 2)
D112 IPP Current into MCLR/VPP pin
â
â
300 μA
D113 IDDP Supply Current during
Programming
â
â
1.0 mA
Data EEPROM Memory
D120 ED Byte Endurance
100K 1M
â E/W -40°C to +85°C
10K 100K â E/W -40°C to +125°C
D121 VDRW VDD for Read/Write
VMIN
â
5.5
V Using EECON to read/write
VMIN = Minimum operating
voltage
D122 TDEW Erase/Write Cycle Time
â
4
â
ms
D123 TRETD Characteristic Retention
40
â
â Year Provided no other
specifications are violated
D124 TREF Number of Total Erase/Write
Cycles before Refresh(1)
1M 10M
100K 1M
â E/W -40°C to +85°C
â E/W -40°C to +125°C
Program Flash Memory
D130 EP Cell Endurance
10K 100K â E/W -40°C to +85°C
1K
10K
â E/W -40°C to +125°C
D131 VPR VDD for Read
VMIN
â
5.5
V VMIN = Minimum operating
voltage
D132 VIE VDD for Block Erase
4.5
â
5.5
V Using ICSP port
D132A VIW VDD for Externally Timed Erase
4.5
â
5.5
V Using ICSP port
or Write
D132B VPEW VDD for Self-timed Write
VMIN
â
5.5
V VMIN = Minimum operating
voltage
D133 TIE ICSP Block Erase Cycle Time
â
4
â
ms VDD > 4.5V
D133A TIW ICSP Erase or Write Cycle Time 1
(externally timed)
â
â
ms VDD > 4.5V
D133A TIW Self-timed Write Cycle Time
â
2
â
ms
D134 TRETD Characteristic Retention
40
â
â Year Provided no other
specifications are violated
â
Note 1:
Data in âTypâ column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Refer to Section 7.8 âUsing the Data EEPROMâ for a more detailed discussion on data EEPROM
endurance.
2: Required only if Low-Voltage Programming is disabled.
DS39599F-page 318
© 2007 Microchip Technology Inc.
|
▷ |