|
PIC18F2220_07 Datasheet, PDF (3/386 Pages) Microchip Technology – 28/40/44-Pin High-Performance, Enhanced Flash Microcontrollers with 10-Bit A/D and nanoWatt Technology | |||
|
◁ |
PIC18F2220/2320/4220/4320
28/40/44-Pin High-Performance, Enhanced Flash MCUs
with 10-bit A/D and nanoWatt Technology
Low-Power Features:
⢠Power-Managed modes:
- Run: CPU on, peripherals on
- Idle: CPU off, peripherals on
- Sleep: CPU off, peripherals off
⢠Power Consumption modes:
- PRI_RUN: 150 μA, 1 MHz, 2V
- PRI_IDLE: 37 μA, 1 MHz, 2V
- SEC_RUN: 14 μA, 32 kHz, 2V
- SEC_IDLE: 5.8 μA, 32 kHz, 2V
- RC_RUN: 110 μA, 1 MHz, 2V
- RC_IDLE: 52 μA, 1 MHz, 2V
- Sleep: 0.1 μA, 1 MHz, 2V
⢠Timer1 Oscillator: 1.1 μA, 32 kHz, 2V
⢠Watchdog Timer: 2.1 μA
⢠Two-Speed Oscillator Start-up
Oscillators:
⢠Four Crystal modes:
- LP, XT, HS: up to 25 MHz
- HSPLL: 4-10 MHz (16-40 MHz internal)
⢠Two External RC modes, up to 4 MHz
⢠Two External Clock modes, up to 40 MHz
⢠Internal oscillator block:
- 8 user selectable frequencies: 31 kHz, 125 kHz,
250 kHz, 500 kHz, 1 MHz, 2 MHz, 4 MHz, 8 MHz
- 125 kHz-8 MHz calibrated to 1%
- Two modes select one or two I/O pins
- OSCTUNE â Allows user to shift frequency
⢠Secondary oscillator using Timer1 @ 32 kHz
⢠Fail-Safe Clock Monitor
- Allows for safe shutdown if peripheral clock stops
Peripheral Highlights:
⢠High current sink/source 25 mA/25 mA
⢠Three external interrupts
⢠Up to 2 Capture/Compare/PWM (CCP) modules:
- Capture is 16-bit, max. resolution is 6.25 ns (TCY/16)
- Compare is 16-bit, max. resolution is 100 ns (TCY)
- PWM output: PWM resolution is 1 to 10-bit
⢠Enhanced Capture/Compare/PWM (ECCP) module:
- One, two or four PWM outputs
- Selectable polarity
- Programmable dead-time
- Auto-Shutdown and Auto-Restart
⢠Compatible 10-bit, up to 13-channel
Analog-to-Digital Converter module (A/D) with
programmable acquisition time
⢠Dual analog comparators
⢠Addressable USART module:
- RS-232 operation using internal oscillator
block (no external crystal required)
Special Microcontroller Features:
⢠100,000 erase/write cycle Enhanced Flash program
memory typical
⢠1,000,000 erase/write cycle Data EEPROM memory
typical
⢠Flash/Data EEPROM Retention: > 40 years
⢠Self-programmable under software control
⢠Priority levels for interrupts
⢠8 x 8 Single-Cycle Hardware Multiplier
⢠Extended Watchdog Timer (WDT):
- Programmable period from 41 ms to 131s
- 2% stability over VDD and Temperature
⢠Single-supply 5V In-Circuit Serial Programmingâ¢
(ICSPâ¢) via two pins
⢠In-Circuit Debug (ICD) via two pins
⢠Wide operating voltage range: 2.0V to 5.5V
Device
Program Memory
Data Memory
MSSP
Flash
(bytes)
# Single Word SRAM EEPROM
Instructions (bytes) (bytes)
I/O
10-bit
A/D (ch)
CCP/
ECCP
(PWM)
SPIâ¢
Master
I2Câ¢
USART
Timers
8/16-bit
PIC18F2220
PIC18F2320
PIC18F4220
PIC18F4320
4096
8192
4096
8192
2048
4096
2048
4096
512
256 25
10
2/0
Y
Y
Y
512
256 25
10
2/0
Y
Y
Y
512
256 36
13
1/1
Y
Y
Y
512
256 36
13
1/1
Y
Y
Y
2
2/3
2
2/3
2
2/3
2
2/3
© 2007 Microchip Technology Inc.
DS39599F-page 1
|
▷ |