C8051F326 Datasheet, PDF (99/140 Pages) List of Unclassifed Manufacturers – Full Speed USB, 16 kB Flash MCU Family

C8051F326/7
12.6. Function Addressing
The FADDR register holds the current USB0 function address. Software should write the host-assigned
7-bit function address to the FADDR register when received as part of a SET_ADDRESS command. A new
address written to FADDR will not take effect (USB0 will not respond to the new address) until the end of
the current transfer (typically following the status phase of the SET_ADDRESS command transfer). The
UPDATE bit (FADDR.7) is set to ‘1’ by hardware when software writes a new address to the FADDR regis-
ter. Hardware clears the UPDATE bit when the new address takes effect as described above.
USB Register Definition 12.7. FADDR: USB0 Function Address
R
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Reset Value
Update
Function Address
00000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0 USB Address:
0x00
Bit7:
Bits6–0:
Update: Function Address Update
Set to ‘1’ when software writes the FADDR register. USB0 clears this bit to ‘0’ when the new
address takes effect.
0: The last address written to FADDR is in effect.
1: The last address written to FADDR is not yet in effect.
Function Address
Holds the 7-bit function address for USB0. This address should be written by software when
the SET_ADDRESS standard device request is received on Endpoint0. The new address
takes effect when the device request completes.
Rev. 0.5
99