C8051F326 Datasheet, PDF (107/140 Pages) List of Unclassifed Manufacturers – Full Speed USB, 16 kB Flash MCU Family

C8051F326/7
12.10.2.Endpoint0 IN Transactions
When a SETUP request is received that requires USB0 to transmit data to the host, one or more IN
requests will be sent by the host. For the first IN transaction, firmware should load an IN packet into the
Endpoint0 FIFO, and set the INPRDY bit (E0CSR.1). An interrupt will be generated when an IN packet is
transmitted successfully. Note that no interrupt will be generated if an IN request is received before firm-
ware has loaded a packet into the Endpoint0 FIFO. If the requested data exceeds the maximum packet
size for Endpoint0 (as reported to the host), the data should be split into multiple packets; each packet
should be of the maximum packet size excluding the last (residual) packet. If the requested data is an inte-
ger multiple of the maximum packet size for Endpoint0, the last data packet should be a zero-length packet
signaling the end of the transfer. Firmware should set the DATAEND bit to ‘1’ after loading into the
Endpoint0 FIFO the last data packet for a transfer.
Upon reception of the first IN token for a particular control transfer, Endpoint0 is said to be in Transmit
Mode. In this mode, only IN tokens should be sent by the host to Endpoint0. The SUEND bit (E0CSR.4) is
set to ‘1’ if a SETUP or OUT token is received while Endpoint0 is in Transmit Mode.
Endpoint0 will remain in Transmit Mode until any of the following occur:
1. USB0 receives an Endpoint0 SETUP or OUT token.
2. Firmware sends a packet less than the maximum Endpoint0 packet size.
3. Firmware sends a zero-length packet.
Firmware should set the DATAEND bit (E0CSR.3) to ‘1’ when performing (2) and (3) above.
The SIE will transmit a NAK in response to an IN token if there is no packet ready in the IN FIFO
(INPRDY = ‘0’).
12.10.3.Endpoint0 OUT Transactions
When a SETUP request is received that requires the host to transmit data to USB0, one or more OUT
requests will be sent by the host. When an OUT packet is successfully received by USB0, hardware will set
the OPRDY bit (E0CSR.0) to ‘1’ and generate an Endpoint0 interrupt. Following this interrupt, firmware
should unload the OUT packet from the Endpoint0 FIFO and set the SOPRDY bit (E0CSR.6) to ‘1’.
If the amount of data required for the transfer exceeds the maximum packet size for Endpoint0, the data
will be split into multiple packets. If the requested data is an integer multiple of the maximum packet size
for Endpoint0 (as reported to the host), the host will send a zero-length data packet signaling the end of the
transfer.
Upon reception of the first OUT token for a particular control transfer, Endpoint0 is said to be in Receive
Mode. In this mode, only OUT tokens should be sent by the host to Endpoint0. The SUEND bit (E0CSR.4)
is set to ‘1’ if a SETUP or IN token is received while Endpoint0 is in Receive Mode.
Endpoint0 will remain in Receive mode until:
1. The SIE receives a SETUP or IN token.
2. The host sends a packet less than the maximum Endpoint0 packet size.
3. The host sends a zero-length packet.
Firmware should set the DATAEND bit (E0CSR.3) to ‘1’ when the expected amount of data has been
received. The SIE will transmit a STALL condition if the host sends an OUT packet after the DATAEND bit
has been set by firmware. An interrupt will be generated with the STSTL bit (E0CSR.2) set to ‘1’ after the
STALL is transmitted.
Rev. 0.5
107