C8051F326 Datasheet, PDF (94/140 Pages) List of Unclassifed Manufacturers – Full Speed USB, 16 kB Flash MCU Family

C8051F326/7
USB Register Definition 12.3. USB0DAT: USB0 Data
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Reset Value
USB0DAT
00000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0 SFR Address:
0x97
This SFR is used to indirectly read and write USB0 registers.
Write Procedure:
1. Poll for BUSY (USB0ADR.7) => ‘0’.
2. Load the target USB0 register address into the USBADDR bits in register USB0ADR.
3. Write data to USB0DAT.
4. Repeat (Step 2 may be skipped when writing to the same USB0 register).
Read Procedure:
1. Poll for BUSY (USB0ADR.7) => ‘0’.
2. Load the target USB0 register address into the USBADDR bits in register USB0ADR.
3. Write ‘1’ to the BUSY bit in register USB0ADR (steps 2 and 3 can be performed in the
same write).
4. Poll for BUSY (USB0ADR.7) => ‘0’.
5. Read data from USB0DAT.
6. Repeat from Step 2 (Step 2 may be skipped when reading the same USB0 register; Step 3
may be skipped when the AUTORD bit (USB0ADR.6) is logic 1).
USB Register Definition 12.4. INDEX: USB0 Endpoint Index
R
R
R
R
R/W
R/W
R/W
R/W
Reset Value
—
—
—
—
EPSEL
00000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0 USB Address:
0x0E
Bits7–4: Unused. Read = 0000b; Write = don’t care.
Bits3–0: EPSEL: Endpoint Select
These bits select which endpoint is targeted when indexed USB0 registers are accessed.
INDEX
0x0
0x1
0x2–0xF
Target Endpoint
0
1
Reserved
94
Rev. 0.5