C8051F326 Datasheet, PDF (61/140 Pages) List of Unclassifed Manufacturers – Full Speed USB, 16 kB Flash MCU Family

C8051F326/7
7.2. Power-Fail Reset / VDD Monitor
When a power-down transition or power irregularity causes VDD to drop below V_RST, the power supply
monitor will drive the RST pin low and hold the CIP-51 in a reset state (see Figure 7.2). When VDD returns
to a level above V_RST, the CIP-51 will be released from the reset state. Note that even though internal data
memory contents are not altered by the power-fail reset, it is impossible to determine if VDD dropped
below the level required for data retention. If the PORSF flag reads ‘1’, the data may no longer be valid.
The VDD monitor is enabled after power-on resets; however its defined state (enabled/disabled) is not
altered by any other reset source. For example, if the VDD monitor is enabled and a software reset is per-
formed, the VDD monitor will still be enabled after the reset.
Important Note: The VDD monitor must be enabled before it is selected as a reset source. Selecting the
VDD monitor as a reset source before it is enabled and stabilized will cause a system reset. The procedure
for configuring the VDD monitor as a reset source is shown below:
Step 1. Enable the VDD monitor (VDM0CN.7 = ‘1’).
Step 2. Wait for the VDD monitor to stabilize (see Table 7.1 for the VDD Monitor turn-on time).
Step 3. Select the VDD monitor as a reset source (RSTSRC.1 = ‘1’).
See Figure 7.2 for VDD monitor timing. See Table 7.1 for complete electrical characteristics of the VDD
monitor.
SFR Definition 7.1. VDM0CN: VDD Monitor Control
R/W
VDMEN
Bit7
R
R
R
R
R
R
R
Reset Value
VDDSTAT Reserved Reserved Reserved Reserved Reserved Reserved Variable
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0 SFR Address:
0xFF
Bit7:
Bit6:
Bits5–0:
VDMEN: VDD Monitor Enable.
This bit turns the VDD monitor circuit on/off. The VDD Monitor cannot generate system
resets until it is also selected as a reset source in register RSTSRC (Figure 7.2). The VDD
Monitor must be allowed to stabilize before it is selected as a reset source. Selecting the
VDD monitor as a reset source before it has stabilized may generate a system reset.
See Table 7.1 for the minimum VDD Monitor turn-on time. The VDD Monitor is enabled fol-
lowing all POR resets.
0: VDD Monitor Disabled.
1: VDD Monitor Enabled.
VDDSTAT: VDD Status.
This bit indicates the current power supply status (VDD Monitor output).
0: VDD is at or below the VDD monitor threshold.
1: VDD is above the VDD monitor threshold.
Reserved. Read = Variable. Write = don’t care.
Rev. 0.5
61