C8051F326 Datasheet, PDF (37/140 Pages) List of Unclassifed Manufacturers – Full Speed USB, 16 kB Flash MCU Family

C8051F326/7
6. CIP-51 Microcontroller
The MCU system controller core is the CIP-51 microcontroller. The CIP-51 is fully compatible with the
MCS-51™ instruction set; standard 803x/805x assemblers and compilers can be used to develop soft-
ware. The MCU family has a superset of all the peripherals included with a standard 8051. Included are
two 16-bit counter/timers (see description in Section 14), an enhanced full-duplex UART (see description
in Section 13), 256 bytes of internal RAM, 128 byte Special Function Register (SFR) address space (Sec-
tion 6.2.6), and 15 Port I/O (see description in Section 11). The CIP-51 also includes on-chip debug hard-
ware (see description in Section 15), and interfaces directly with the USB and other digital subsystems
providing a complete solution in a single integrated circuit.
The CIP-51 Microcontroller core implements the standard 8051 organization and peripherals as well as
additional custom peripherals and functions to extend its capability (see Figure 6.1 for a block diagram).
The CIP-51 includes the following features:
- Fully Compatible with MCS-51 Instruction
Set
- 25 MIPS Peak Throughput with 25 MHz
Clock
- 0 to 25 MHz Clock Frequency
- 256 Bytes of Internal RAM
- 15 Port I/O
- Extended Interrupt Handler
- Reset Input
- Power Management Modes
- On-chip Debug Logic
- Program and Data Memory Security
DATA BUS
ACCUMULATOR
TMP1
TMP2
PSW
ALU
B REGISTER
STACK POINTER
SRAM
ADDRESS
REGISTER
SRAM
(256 X 8)
DATA BUS
BUFFER
D8
DATA POINTER
D8
PC INCREMENTER
SFR_ADDRESS
SFR
SFR_CONTROL
D8
BUS
SFR_WRITE_DATA
INTERFACE
SFR_READ_DATA
PROGRAM COUNTER (PC)
PRGM. ADDRESS REG.
RESET
CLOCK
CONTROL
LOGIC
PIPELINE
STOP
IDLE
POWER CONTROL
REGISTER
D8
D8
MEM_ADDRESS
MEM_CONTROL
MEMORY
A16
INTERFACE ^{MEM_WRITE_DATA}
MEM_READ_DATA
D8
INTERRUPT
D8
INTERFACE
SYSTEM_IRQs
EMULATION_IRQ
Figure 6.1. CIP-51 Block Diagram
Rev. 0.5
37