AMIS-53000 Datasheet, PDF (91/99 Pages) AMI SEMICONDUCTOR – Frequency Agile Transceiver

AMIS-53000 Frequency Agile Transceiver
Data Sheet
8.3.1. Crystal Temperature Compensation
An on-chip temperature sensor combined with an on-chip A/D and a look-up table enable the part to maintain RF frequency accuracy
within ± 2.5ppm over all operating voltages and temperatures (-45°C to 85°C). This function can be enabled via configuration bit 4
located in general options A. When this function is enabled, a new calculation for the center frequency word will be performed
whenever the temperature sensor storage register is updated with a new value. Therefore it is possible to update the compensation
value either in housekeeping, as part of a Burst transmit cycle, or as controlled externally by issuing the instruction to perform an ADC
measurement of the temp sensor.
Table 111: RF Frequency Temperature Compensation
Register
Number (HEX) Name
Function
Bits
0X0C
General Options A 4
Enable RF frequency temperature compensation
8.4 Software
The version of the AMIS-53000 is written to a register at the end of the manufacturing process. This code can help AMIS wireless
product support when there is an issue with the AMIS-53000.
Setup registers descriptions:
AMIS ID- Register contains a code showing the version of the AMIS-53000.
8.4.1. AMIS Part Revision Code
Table 112: AMIS Part Revision Code - 0X41 [65]
Bit Name
Comment
7:0 _{AMIS_ID [7:0]}
Revision status of the AMIS-53000
AMI Semiconductor – Aug. 05, Rev. 1.0
91
www.amis.com