AMIS-53000 Datasheet, PDF (65/99 Pages) AMI SEMICONDUCTOR – Frequency Agile Transceiver

AMIS-53000 Frequency Agile Transceiver
Data Sheet
6.7.3. Burst Transmit Data
Table 59: Burst Transmission Configuration
Register
Number (HEX) Name
Bits
0X10
Idle Config
1
Function
Enable Burst transmissions
Burst mode of transmission is a function that can cause the AMIS-53000 to transmit a message at a programmed time interval or by
asserting the xBURST pin to active (the AMIS-53000 must be in the xBURST mode), causing the AMIS-53000 to immediately transmit
a message. The Burst mode can also be started by enabling the Burst mode in the idle register and then writing to the command
register to set the AMIS-53000 into idle mode. The xBURST modes sets a timed automatic transmission of register values (a message)
or ADC conversion values.
Setup registers descriptions:
Burst Config- Set the Burst transmission parameters.
Burst Interval- Set the time interval between Burst transmissions.
User DataA- Message for timer initiated transmissions.
User DataB- Message for xBURST initiated transmissions.
Figure 41: Data Packet Format Showing Order for Burst TX Content
AMI Semiconductor – Aug. 05, Rev. 1.0
65
www.amis.com