AMIS-53000 Datasheet, PDF (8/99 Pages) AMI SEMICONDUCTOR – Frequency Agile Transceiver

AMIS-53000 Frequency Agile Transceiver
Data Sheet
2.0 Operational Specifications
2.1 Absolute Maximum Ratings
Table 1: Absolute Maximum Ratings
Symbol
Parameter
Vdd
DC Supply Voltage
Vin
Input Pin Voltage
Iin
Input Pin Current
Tstrg
Storage Temperature
Tlead
Lead Temperature
ESD_HBM
Human Body Model
ESD_CDM
Charged-Device Model
ESD_MM
Machine Model
Min.
-0.3
-0.3
-10.0
-55
Max.
3.6
Vdd+0.3
10.0
150
300
2
750
200
Units
V
V
mA
C
C
kV
V
V
Notes
25C
SSOP
10 SEC
2.2 Recommended Operating Conditions
Table 2: Operating Conditions
Symbol
Parameter
Vdd
DC Supply
Idd
Dynamic Current
Idds
Standby Current (off current)
Vss
Ground
Ta
Ambient Temperature
Min.
2.2
0.0
-40
Max.
3.3
70
2
0.0
85
Units
V
mA
uA
V
C
Notes
(1) Continuous TX
(2)
Notes:
1. Dynamic current is with the transmitter enabled at maximum output power + 15dBm in FSK mode at 928MHz.
2. Standby current is with all analog cells in power down. Other logic powered up with no clocks running. All outputs unloaded and inputs tied high or low.
No floating inputs.
2.2.1. Parametric Voltage and Current Levels
(Testing for the below currents assumes a static test setup with measurements performed while static data is applied to the device.)
2.2.1.1. Inputs
Table 3: Pin Input Parameters
Pin
Vil
Vih
AI
DISU
DISC
Min.
(V)
Max.
(V)
0.0
0.3
0.0
0.3
Min.
(V)
0.8
0.8
Max.
(V)
1.0
1.0
Iil
(1)
Min. Max.
uA
uA
0.0
1.0
0.0
1.0
0.0
1.0
Iih
(1)
Min. Max.
uA
uA
-1.0
0.0
-30
-90
-1.0
0.0
Notes
(2)
Analog input
CMOS with pull up Schmitt
CMOS Schmitt
Notes:
1. Iil and Iih are tested at Vdd = VDDmax volts. Not tested at less than room temperature.
2. PU = Pull up, PD = Pull down, SC = Schmitt, SU = Schmitt & Pull up and SD = Schmitt and Pull down.
3. CMOS values are 'Vin * VDD' and TTL values are absolute voltages.
AMI Semiconductor – Aug. 05, Rev. 1.0
8
www.amis.com