EP2S15 Datasheet, PDF (139/238 Pages) Altera Corporation – Stratix II Device Family

DC & Switching Characteristics
Table 5–3. Stratix II Device Recommended Operating Conditions (Part 2 of 2) Note (1)
Symbol
Parameter
T_J
Operating junction temperature
Conditions
For commercial use
For industrial use
Minimum Maximum Unit
0
85
°C
–40
100
°C
Notes to Table 5–3:
(1) Supply voltage specifications apply to voltage readings taken at the device pins, not at the power supply.
(2) During transitions, the inputs may overshoot to the voltage shown in Table 5–2 based upon the input duty cycle.
The DC case is equivalent to 100% duty cycle. During transitions, the inputs may undershoot to –2.0 V for input
currents less than 100 mA and periods shorter than 20 ns.
(3) Maximum V_CC rise time is 100 ms, and V_CC must rise monotonically from ground to V_{C C} .
(4) V_CCPD must ramp-up from 0 V to 3.3 V within 100 μs to 100 ms. If V_{C C P D} is not ramped up within this specified
time, your Stratix II device does not configure successfully. If your system does not allow for a V_CCPD ramp-up time
of 100 ms or less, you must hold nCONFIG low until all power supplies are reliable.
(5) All pins, including dedicated inputs, clock, I/O, and JTAG pins, may be driven before V_CCINT, V_CCPD, and V_CCIO
are powered.
(6) V_{C C I O} maximum and minimum conditions for PCI and PCI-X are shown in parentheses.
DC Electrical Characteristics
Table 5–4 shows the Stratix II device family DC electrical characteristics.
Table 5–4. Stratix II Device DC Operating Conditions (Part 1 of 2) Note (1)
Symbol
Parameter
Conditions
I_I
I_OZ
I_{C C I N T 0}
Input pin leakage current V_I = V_CCIOmax to 0 V (2)
Tri-stated I/O pin
leakage current
V_O = V_CCIOmax to 0 V (2)
V_CCINT supply current
(standby)
V_I = ground, no
load, no toggling
inputs
T_J = 25° C
EP2S15
EP2S30
EP2S60
EP2S90
EP2S130
EP2S180
I_CCPD0
V_CCPD supply current
(standby)
V_I = ground, no
load, no toggling
inputs
T_J = 25° C,
V_CCPD = 3.3V
EP2S15
EP2S30
EP2S60
EP2S90
EP2S130
EP2S180
Minimum Typical Maximum Unit
–10
10
μA
–10
10
μA
0.25
(3)
A
0.30
(3)
A
0.50
(3)
A
0.62
(3)
A
0.82
(3)
A
1.12
(3)
A
2.2
(3)
mA
2.7
(3)
mA
3.6
(3)
mA
4.3
(3)
mA
5.4
(3)
mA
6.8
(3)
mA
Altera Corporation
May 2007
5–3
Stratix II Device Handbook, Volume 1