DS923 Datasheet, PDF (52/56 Pages) Xilinx, Inc – DC and AC Switching Characteristics

Virtex UltraScale+ FPGA Data Sheet: DC and AC Switching Characteristics
Table 61: SYSMON Specifications (Cont’d)
Parameter
Symbol
Comments/Conditions
Min Typ Max Units
Supply voltages 0.72V to 1.2V, T_j = –
40°C to 100°C (with external REF)
–
–
±0.5
%
Supply sensor error⁽³⁾
Supply voltages 0.72V to 1.2V,
T_j = –55°C to 125°C (with external REF)
–
All other supply voltages,
T_j = –40°C to 100°C (with external REF)
–
All other supply voltages,
T_j = –55°C to 125°C (with external REF)
–
Supply voltages 0.72V to 1.2V, T_j = –
40°C to 100°C (with internal REF)
–
–
±1.0
%
–
±1.0
%
–
±2.0
%
–
±1.0
%
Conversion Rate⁽⁴⁾
Supply voltages 0.72V to 1.2V,
T_j = –55°C to 125°C (with internal REF)
–
All other supply voltages,
T_j = –40°C to 100°C (with internal REF)
–
All other supply voltages,
T_j = –55°C to 125°C (with internal REF)
–
–
±2.0
%
–
±1.5
%
–
±2.5
%
Conversion time—continuous t_CONV
Conversion time—event
t_CONV
DRP clock frequency
DCLK
Number of ADCCLK cycles
Number of ADCCLK cycles
DRP clock frequency
26
–
32
Cycles
–
–
21
Cycles
8
–
250
MHz
ADC clock frequency
ADCCLK Derived from DCLK
1
–
5.2
MHz
DCLK duty cycle
40
–
60
%
SYSMON Reference⁽⁵⁾
External reference
On-chip reference
V_REFP Externally supplied reference voltage
1.20 1.25 1.30
V
Ground V_REFP pin to AGND,
T_j = –40°C to 100°C
1.2375 1.25 1.2625
V
Ground V_REFP pin to AGND,
T_j = –55°C to 125°C
1.225 1.25 1.275
V
Notes:
1. ADC offset errors are removed by enabling the ADC automatic offset calibration feature. The values are specified for when
this feature is enabled.
2. See the Analog Input section in the UltraScale Architecture System Monitor User Guide (UG580).
3. Supply sensor offset and gain errors are removed by enabling the automatic offset and gain calibration feature. The values
are specified for when this feature is enabled.
4. See the Adjusting the Acquisition Settling Time section in the UltraScale Architecture System Monitor User Guide (UG580).
5.
Any variation
ideal transfer
in the reference voltage from the nominal
function. This also impacts the accuracy of
Vth_{REeFPin=ter1n.a2l5sVenansodr}
Vm_{REeFaNsu=re0mVewnitlsl}
result in a deviation from the
(i.e., temperature and power
supply). However, for external ratiometric type applications allowing reference to vary by ±4% is permitted.
DS923 (v1.0) April 20, 2016
Advance Product Specification
www.xilinx.com
Send Feedback
52