DS923 Datasheet, PDF (4/56 Pages) Xilinx, Inc – DC and AC Switching Characteristics

Virtex UltraScale+ FPGA Data Sheet: DC and AC Switching Characteristics
Table 2: Recommended Operating Conditions⁽¹⁾⁽²⁾ (Cont’d)
Symbol
Description
SYSMON
V_CCADC
V_REFP
Temperature
SYSMON supply relative to GNDADC.
Externally supplied reference voltage.
Junction temperature operating range for extended (E)
temperature devices.⁽¹¹⁾
T_j
Junction temperature operating range for industrial (I)
temperature devices.
Min
Typ
1.746
1.200
1.800
1.250
0
–
–40
–
Max
1.854
1.300
Units
V
V
100
°C
100
°C
Notes:
1. All voltages are relative to GND.
2. For the design of the power distribution system consult UltraScale Architecture PCB Design Guide (UG583).
3. V_{CCINT_IO} must be connected to V_CCBRAM.
4. _{cFoonr fVigCuCrOa_t0io, nth,} edamtainiismruemtairneecdomevmeennidf eVd_CCo_Opedrraotpinsgtovo0lVta.ge for power on and during configuration is 1.425V. After
5. Includes V_CCO of 1.0V, 1.2V, 1.35V, 1.5V, and 1.8V.
6. V_{CCAUX_IO} must be connected to V_CCAUX.
7. The lower absolute voltage specification always applies.
8. A total of 200 mA per 52-pin bank should not be exceeded.
9. If battery is not used, connect V_BATT to either GND or V_CCAUX.
10. Each voltage listed requires filtering as described in the UltraScale Architecture GTY Transceiver User Guide (UG578).
11. Devices labeled with the speed/temperature grade of -2LE can operate for a limited time at a junction temperature of
110°C. Timing parameters adhere to the same speed file at 110°C as they do below 110°C, regardless of operating voltage
(nominal voltage of 0.85V or a low-voltage of 0.72V). Operation at Tj = 110°C is limited to 1% of the device lifetime and
can occur sequentially or at regular intervals as long as the total time does not exceed 1% of the device lifetime.
DS923 (v1.0) April 20, 2016
Advance Product Specification
www.xilinx.com
Send Feedback
4