TA1317AN Datasheet, PDF (44/59 Pages) Toshiba Semiconductor – TOSHIBA Bipolar Linear Integrated Circuit Silicon Monolithic

Note
No.
Parameter
26 Sawtooth correction
(cent saw) maximum
amplitude
TA1317AN
SW5
OFF
SW6
B
SW7
ON
Test Condition
SW Mode
SW8 SW10 SW11 SW17 SW24
Test Method
(unless otherwise specified, V_CC = 9 V, Ta = 25 ± 3°C, data = preset values)
OFF B
ON
A
A (1) Input vertical trigger pulse to pin V_IN.
Pulse level (VT) = 3.0 V
(2) Set CENTER SAW (sub-address: 10) to maximum (data: 8F) and measure pin 19
(CENT OUT) amplitude V_N (8F).
(3) Set CENTER SAW (sub-address: 10) to minimum (data: 80) and measure pin 19
(CENT OUT) amplitude V_N (80).
27 Parabola correction (cent par) OFF B
ON OFF B
ON
A
maximum amplitude
V_N (80)
Pin 19 (CENT OUT) waveform
V_N (8F)
Pin 19 (CENT OUT) waveform
A (1) Input vertical trigger pulse to pin V_IN.
Pulse level (VT) = 3.0 V
(2) Set CENTER PARABOLA (sub-address: 10) to maximum (data: F8) and measure
pin 19 (CENT OUT) amplitude V_P (F8).
(3) Set CENTER PARABOLA (sub-address: 10) to minimum (data: 08) and measure
pin 19 (CENT OUT) amplitude V_P (08).
V_P (F8)
Pin 19 (CENT OUT) waveform
V_P (08)
Pin 19 (CENT OUT) waveform
44
2002-09-06