TA1317AN Datasheet, PDF (36/59 Pages) Toshiba Semiconductor – TOSHIBA Bipolar Linear Integrated Circuit Silicon Monolithic

Note
No.
Parameter
17 Parabola amplitude
adjustment (EW parabola)
change amount
TA1317AN
SW5
OFF
SW6
B
SW7
ON
Test Condition
SW Mode
SW8 SW10 SW11 SW17 SW24
Test Method
(unless otherwise specified, V_CC = 9 V, Ta = 25 ± 3°C, data = preset values)
OFF B
ON
A
A (1) Input vertical trigger pulse to pin V_IN.
Pulse level (VT) = 3.0 V
(2) Set PICTURE WIDTH (sub-address: 01) to maximum (data: FC).
(3) Apply external power supply (DC voltage = 7 V) to pin 3 (EHT IN).
(4) Set EW PARABOLA (sub-address: 0A) to minimum (data: 00) and measure Pin 10
(EW FD) amplitude V_PB (00).
(5) Set EW PARABOLA (sub-address: 0A) to center (data: 20) and measure Pin 10
(EW FD) amplitude V_PB (20).
(6) Set EW PARABOLA (sub-address: 0A) to maximum (data: 3F) and measure Pin 10
(EW FD) amplitude V_PB (3F).
(7) Calculate change amount V_PB using the following formula.
Pin 10 (EW FD) waveform
V_PB = V_PB (3F) − V_PB (00)
36
2002-09-06