DS90UB913A-Q1 Datasheet, PDF (3/51 Pages) Texas Instruments – 25-MHz to 100-MHz 10/12-Bit FPD-Link III Serializer

www.ti.com
DS90UB913A-Q1
SNLS443C – MAY 2013 – REVISED APRIL 2016
Revision History (continued)
• Updated frequency requirements for 10-bit and 12-bit HF modes. 10-bit mode – 50 MHz to 100 MHz; 12-bit HF
mode – 37.5 MHz to 75 MHz; 12-bit LF mode (no change) – 25 MHz to 50 MHz. ............................................................ 16
• Updated register 0x01[1] default value to be “0”. ................................................................................................................. 29
• Changed GPO0 Enable for 0x0D[4] to GPO1 Enable.......................................................................................................... 31
• Added Inject Forward Channel Error Register 0x2D. ........................................................................................................... 34
• Updated power up sequencing information and timing diagram. ........................................................................................ 35
• Added description specifying that the voltage applied on V_DDIO (1.8V, 3.3V) or V_{DD_n} (1.8V) should be at the input
pin – any board level DC drop should be compensated. .................................................................................................... 41
• Added 913A EVM layout example image. ........................................................................................................................... 44
Changes from Revision A (June 2013) to Revision B
Page
• Added datasheet flow and layout to conform with new TI standards. Added the following sections: Device
Comparison Table; Handling Ratings; Application and Implementation; Power Supply Recommendations; Layout;
Device and Documentation Support; Mechanical, Packaging, and Ordering Information .................................................... 1
• Added additional thermal characteristics................................................................................................................................ 7
• Changed typo in Vout test condition from R_L=500Ω to R_L=50Ω. .......................................................................................... 8
• Changed Figure 6 to use V_ODp-p and to clarify difference between STP and Coax .............................................................. 12
• Added Internal Oscillator section to Device Functional Modes ............................................................................................ 22
• Added reference to Power over Coax Application report ..................................................................................................... 35
• Added power up sequencing information and timing diagram. ............................................................................................ 35
Copyright © 2013–2016, Texas Instruments Incorporated
Product Folder Links: DS90UB913A-Q1
Submit Documentation Feedback
3