C8051F336 Datasheet, PDF (36/234 Pages) Silicon Laboratories – Mixed Signal ISP Flash MCU Family

C8051F336/7/8/9
Table 6.2. Global Electrical Characteristics (Continued)
–40 to +85 °C, 25 MHz system clock unless otherwise specified.
Parameter
Conditions
Min Typ Max Units
I_DD Supply Sensitivity (Note 3) F = 25 MHz
F = 1 MHz
— TBD — %/V
— TBD — %/V
I_DD Frequency Sensitivity
(Note 3, Note 5)
V_DD = 3.0 V, F < 1 MHz, T = 25 °C
V_DD = 3.0 V, F > 1 MHz, T = 25 °C
— TBD — mA/MHz
— TBD — mA/MHz
V_DD = 3.6 V, F < 1 MHz, T = 25 °C
— TBD — mA/MHz
V_DD = 3.6 V, F > 1 MHz, T = 25 °C
— TBD — mA/MHz
Digital Supply Current
Oscillator not running,
(Stop or Suspend Mode, shut- V_DD Monitor Disabled
down)
— < 0.1 —
µA
Notes:
1. Given in Table 6.4 on page 37.
2. SYSCLK must be at least 32 kHz to enable debugging.
3. Based on device characterization data; Not production tested.
4. IDD can be estimated for frequencies <= 15 MHz by simply multiplying the frequency of interest by the
frequency sensitivity number for that range. When using these numbers to estimate I_DD for >15 MHz, the
estimate should be the current at 25 MHz minus the difference in current indicated by the frequency
sensitivity number. For example: V_DD = 3.0 V; F = 20 MHz, I_DD = 7.8 mA - (25 MHz -
20 MHz) * 0.21 mA/MHz = 6.75 mA.
5. Idle IDD can be estimated for frequencies <= 1 MHz by simply multiplying the frequency of interest by the
frequency sensitivity number for that range. When using these numbers to estimate Idle I_DD for >1 MHz, the
estimate should be the current at 25 MHz minus the difference in current indicated by the frequency
sensitivity number. For example: V_DD = 3.0 V; F = 5 MHz, Idle I_DD = 4.8 mA - (25 MHz -
5 MHz) * 0.15 mA/MHz = 1.8 mA.
Table 6.3. Port I/O DC Electrical Characteristics
V_DD = 2.7 to 3.6 V, –40 to +85 °C unless otherwise specified.
Parameters
Output High Voltage
Conditions
I_OH = –3 mA, Port I/O push-pull
I_OH = –10 µA, Port I/O push-pull
I_OH = –10 mA, Port I/O push-pull
I_OL = 8.5 mA
Min
V_DD – 0.7
V_DD – 0.1
—
—
Typ
—
—
V_DD – 0.8
—
Max
—
—
—
0.6
Units
V
Output Low Voltage
Input High Voltage
Input Low Voltage
Input Leakage
Current
I_OL = 10 µA
I_OL = 25 mA
Weak Pullup Off
Weak Pullup On, V_IN = 0 V
—
—
0.1
V
—
1.0
—
2.0
—
—
V
—
—
0.8
V
—
—
±1
µA
—
50
100
36
Rev. 0.2