HD66787 Datasheet, PDF (114/159 Pages) Renesas Technology Corp – 528-channel, One-chip Driver with 262,144-color Display RAM and Power Supply Circuit for Low-temperature Poli-Si TFT (LTPS-TFT) Panels with Incorporat

HD66787
Preliminary
3. Write mode 3: AM = 0, LG2–0 = 110/111
This mode is used when data are horizontally written with comparing the write data and the value set in the
compare register (CP17–0) by R, G, B pixel. When the result of the comparison satisfies a condition, the
write data sent from the microcomputer are written to GRAM. In this operation, the write-data mask
function (WM17–0) is available. After writing, the address counter (AC) automatically increments by 1
(I/D = 1) or decrements by 1 (I/D = 0), and jumps to the counter at the opposing edge of the next one-
raster-row below after when the counter reaches either left or right edge of GRAM.
Operation example
1) I/D = "1", AM = "0", LG2-0 = "110" (matched writing)
2)CP17-0 = "050C0"H
3)WM17-0 = "00000"H
4) AC = "0000"H
WM17
WM0
Write-data mask: _{0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0}
CP17
CP0
Compare register: _{0 0 0 1 0 1 0 0 0 0 1 1 0 0 0 0 0 0} ^{Compare operation}
DB17
(Matched)
DB0
Write-data (1): _{0 0 0 1 0 1 0 0 0 0 1 1 0 0 0 0 0 0} C
Conditional replacement
R _{000101000011000000}
Write-data (2):
Compare
operation
Replacement
Conditional replacement
000000111111000000 C R * * * * * * * * * * * * * * * * * *
Data are expanded into 18 bits in 8/16-bit system
interface, and 16-bit RGB interface modes.
"0000"H
"0001"H
000101000011000000 * * * * * * * * * * * * * * * * * *
write data (1)
matched
replacement
GRAM
Write Mode 3
Rev.0.22, May.23.2003, page 114 of 159