HD66787 Datasheet, PDF (113/159 Pages) Renesas Technology Corp – 528-channel, One-chip Driver with 262,144-color Display RAM and Power Supply Circuit for Low-temperature Poli-Si TFT (LTPS-TFT) Panels with Incorporat

HD66787
Preliminary
2.
Write mode 2: AM = 1, LG2–0 = 000
This mode is used when data are vertically written in high speed mode. It is also used to initialize the
graphics RAM (GRAM), develop font patterns or to draw a line vertically. The write-data mask function
(WM17–0) is also available in these operations. After writing, the address counter (AC) automatically
increments by 256, and automatically jumps to the counter either at the top of the next right row (ID = 1) or
at the top of the next left row (I/D = 0) according to the setting in the I/D bit, when the address reaches the
bottom of GRAM.
Operation example
1) I/D = "1", AM = "1", LG2-0 = "000"
2) WM17-0 = "00FFF"H
3) AC = "0000"H
WM17
WM0
Write-data mask: _{0 0 0 0 0 0 1 1 1 1 1 1 1 1 1 1 1 1}
DB17
DB0
Write-data (1): _{1 0 0 1 1 1 1 1 1 1 0 0 1 0 1 0 0 0}
Write-data (2):
Write-data (3):
1 1 0 0 0 1 0 0 0 0 0 1 1 0 0 0 0 0 Data are expanded into 18 bits in 8/16-bit system
interface, and 16-bit RGB interface modes.
011110100010000011
“0000”H ^{1 0 0 1 1 1 * * * * * * * * * * * *} Write-data (1)
“0001”H 1 1 0 0 0 1 * * * * * * * * * * * * Write-data (2)
“0002”H 0 1 1 1 1 0 * * * * * * * * * * * * Write-data (3)
GRAM
Note 1) The bits in the GRAM with “*”are not overwritten.
Note 2) After writing data to the address "EF00"H, the address counter jumps to
"0001"H.
Write Mode 2
Rev.0.22, May.23.2003, page 113 of 159