UPD78F4216A Datasheet, PDF (22/60 Pages) NEC – MOS INTEGRATED CIRCUIT

µPD78F4216A, 78F4218A, 78F4216AY, 78F4218AY
6. PROGRAMMING FLASH MEMORY
The flash memory can be written with the µPD78F4218AY mounted on the target board (on-board). To do so,
connect a dedicated flash programmer (Flashpro II (part number: FL-PR2), Flashpro III (part number: FL-PR3, PG-
FP3) to the host machine and target system.
Writing to flash memory can also be performed using flash memory writing adapter connected to Flashpro II or
Flashpro III.
Remark FL-PR2 and FL-PR3 are products of Naito Densei Machida Mfg. Co., Ltd.
6.1 Selecting Communication Mode
To write the flash memory, use Flashpro II and Flashpro III by serial communication. Select a serial
communication mode from those listed in Table 6-1 in the format shown in Figure 6-1. Each communication mode is
selected by the number of VPP pulses shown in Table 6-1.
Communication
Mode
3-wire serial I/O
Handshake^{Note 2}
UART
Table 6-1. Communication Modes
Number of
Channels
3
1
2
Pins Used
SCK0/P27/SCL0^{Note 1}
SO0/P26
SI0/P25/SDA0^{Note 1}
SCK1/ASCK1/P22
SO1/TxD1/P21
SI1/RxD1/P20
SCK2/ASCK2/P72
SO2/TxD2/P71
SI2/RxD2/P70
SCK0/P27/SCL0^{Note 1}
SO0/P26
SI0/P25/SDA0^{Note 1}
P24/BUZ
TxD1/SO1/P21
RxD1/SI1/P20
TxD2/SO2/P71
RxD2/SI2/P70
Number of
VPP Pulses
0
1
2
3
8
9
Notes 1. The SCL0 and SDA0 pins are available in the µPD78F4216AY, 78F4218AY only.
2. This made is available in the µPD78F4216A, 78F4216AY (other than I, K, E standard)
This made is available in the µPD78F4218A, 78F4218AY (other than I standard)
Caution Be sure to select a communication mode with the number of VPP pulses shown in Table 6-1.
22
Data Sheet U14125EJ1V0DS00