PIC16F872_06 Datasheet, PDF (86/168 Pages) Microchip Technology – 28-Pin, 8-Bit CMOS Flash Microcontroller with 10-Bit A/D

PIC16F872
10.4 A/D Conversions
Clearing the GO/DONE bit during a conversion will
abort the current conversion. The A/D result register
pair will NOT be updated with the partially completed
A/D conversion sample. That is, the
ADRESH:ADRESL registers will continue to contain
the value of the last completed conversion (or the last
value written to the ADRESH:ADRESL registers). After
the A/D conversion is aborted, acquisition on the
selected channel is automatically started. The
GO/DONE bit can then be set to start the conversion.
In Figure 10-3, after the GO bit is set, the first time seg-
ment has a minimum of TCY and a maximum of TAD.
Note: The GO/DONE bit should NOT be set in
the same instruction that turns on the A/D.
FIGURE 10-3:
A/D CONVERSION TAD CYCLES
TCY to TAD TAD1 TAD2 TAD3 TAD4 TAD5 TAD6 TAD7 TAD8 TAD9 TAD10 TAD11
b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
Conversion Starts
Holding capacitor is disconnected from analog input (typically 100 ns)
Set GO bit
ADRES is loaded
GO bit is cleared
ADIF bit is set
Holding capacitor is connected to analog input
10.4.1 A/D RESULT REGISTERS
The ADRESH:ADRESL register pair is the location
where the 10-bit A/D result is loaded at the completion
of the A/D conversion. This register pair is 16-bits wide.
The A/D module gives the flexibility to left or right justify
the 10-bit result in the 16-bit result register. The A/D
Format Select bit (ADFM) controls this justification.
Figure 10-4 shows the operation of the A/D result justi-
fication. The extra bits are loaded with ’0’s’. When an
A/D result will not overwrite these locations (A/D
disable), these registers may be used as two general
purpose 8-bit registers.
FIGURE 10-4:
A/D RESULT JUSTIFICATION
ADFM = 1
10-Bit Result
ADFM = 0
7
2107
0
0000 00
ADRESH
ADRESL
10-bit Result
Right Justified
7
0765
0
0000 00
ADRESH
ADRESL
10-bit Result
Left Justified
DS30221C-page 84
© 2006 Microchip Technology Inc.