English
Language : 

PIC18F86K22-I Datasheet, PDF (488/550 Pages) Microchip Technology – 64/80-Pin, High-Performance, 1-Mbit Enhanced Flash Microcontrollers
PIC18F87K22 FAMILY
31.2 DC Characteristics: Power-Down and Supply Current
PIC18F87K22 Family (Industrial/Extended)
PIC18F87K22 Family
(Industrial/Extended)
Standard Operating Conditions (unless otherwise stated)
Operating temperature
-40°C  TA  +85°C for industrial
-40°C  TA  +125°C for extended
Param
No.
Device
Typ
Max Units
Conditions
Note
Power-Down Current (IPD)(1)
All devices 10
500 nA
-40°C
20
500 nA
+25°C
VDD = 1.8V(4)
120
600 nA
630
1800 nA
+60°C
+85°C
(Sleep mode)
Regulator Disabled
4
9
µA
+125ºC
All devices 50
700 nA
-40°C
60
700 nA
170
800 nA
700
2700 nA
+25°C
+60°C
+85°C
VDD = 3.3V(4)
(Sleep mode)
Regulator Disabled
5
11
µA
+125ºC
All devices 350
1300 nA
-40°C
400
550
1350
1400 nA
1500 nA
4000 nA
+25°C
+60°C
+85°C
VDD = 5V(5)
(Sleep mode)
Regulator Enabled
6
12 µA
+125ºC
1: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in a high-impedance state and tied to VDD or VSS, and all features that add delta
current are disabled (such as WDT, SOSC oscillator, BOR, etc.).
2: The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on
the current consumption.
The test conditions for all IDD measurements in Active Operation mode are:
OSC1 = External square wave, from rail-to-rail; all I/O pins tri-stated, pulled to VDD;
MCLR = VDD; WDT enabled/disabled as specified.
3: Standard, low-cost 32 kHz crystals have an operating temperature range of -10°C to +70°C. Extended temperature
crystals are available at a much higher cost.
4: Voltage regulator disabled (ENVREG = 0, tied to VSS, RETEN (CONFIG1L<0>) = 1).
5: Voltage regulator enabled (ENVREG = 1, tied to VDD, SRETEN (WDTCON<4>) = 1 and RETEN (CONFIG1L<0>) = 0).
6: 48 MHz, maximum frequency at +125ºC.
DS39960D-page 488
 2011 Microchip Technology Inc.