PIC18F2450_08 Datasheet, PDF (37/324 Pages) Microchip Technology – 28/40/44-Pin, High-Performance, 12 MIPS, Enhanced Flash, USB Microcontrollers with nanoWatt Technology

PIC18F2450/4450
On transitions from SEC_RUN mode to PRI_RUN
mode, the peripherals and CPU continue to be clocked
from the Timer1 oscillator while the primary clock is
started. When the primary clock becomes ready, a
clock switch back to the primary clock occurs (see
Figure 3-2). When the clock switch is complete, the
T1RUN bit is cleared, the OSTS bit is set and the
primary clock is providing the clock. The IDLEN and
SCS bits are not affected by the wake-up; the Timer1
oscillator continues to run.
FIGURE 3-1:
TRANSITION TIMING FOR ENTRY TO SEC_RUN MODE
Q1 Q2 Q3 Q4 Q1
Q2 Q3 Q4 Q1 Q2 Q3
T1OSI
OSC1
123
n-1 n
Clock Transition⁽¹⁾
CPU
Clock
Peripheral
Clock
Program
Counter
PC
Note 1: Clock transition typically occurs within 2-4 TOSC.
PC + 2
PC + 4
FIGURE 3-2:
TRANSITION TIMING FROM SEC_RUN MODE TO PRI_RUN MODE (HSPLL)
Q1
Q2
Q3
Q4 Q1
Q2 Q3 Q4 Q1 Q2 Q3
T1OSI
OSC1
PLL Clock
Output
CPU Clock
TOST⁽¹⁾
TPLL⁽¹⁾
1 2 n-1 n
Clock⁽²⁾
Transition
Peripheral
Clock
Program
Counter
PC
PC + 2
SCS1:SCS0 bits Changed
OSTS bit Set
Note 1: TOST = 1024 TOSC; TPLL = 2 ms (approx). These intervals are not shown to scale.
2: Clock transition typically occurs within 2-4 TOSC.
PC + 4
© 2008 Microchip Technology Inc.
DS39760D-page 35