PIC18F2450_08 Datasheet, PDF (127/324 Pages) Microchip Technology – 28/40/44-Pin, High-Performance, 12 MIPS, Enhanced Flash, USB Microcontrollers with nanoWatt Technology

PIC18F2450/4450
13.3 Compare Mode
In Compare mode, the 16-bit CCPR1 register value is
constantly compared against the TMR1 register pair
value. When a match occurs, the CCP1 pin can be:
• driven high
• driven low
• toggled (high-to-low or low-to-high)
• remain unchanged (that is, reflects the state of the
I/O latch)
The action on the pin is based on the value of the mode
select bits (CCP1M3:CCP1M0). At the same time, the
interrupt flag bit, CCP1IF, is set.
13.3.1 CCP1 PIN CONFIGURATION
The user must configure the CCP1 pin as an output by
clearing the appropriate TRIS bit.
Note:
Clearing the CCP1CON register will force
the RC2 compare output latch to the
default low level.
13.3.2 TIMER1 MODE SELECTION
Timer1 must be running in Timer mode, or
Synchronized Counter mode, if the CCP module is
using the compare feature. In Asynchronous Counter
mode, the compare operation may not work.
13.3.3 SOFTWARE INTERRUPT MODE
When the Generate Software Interrupt mode is chosen
(CCP1M3:CCP1M0 = 1010), the CCP1 pin is not
affected. Only a CCP interrupt is generated, if enabled,
and the CCP1IE bit is set.
13.3.4 SPECIAL EVENT TRIGGER
The CCP module is equipped with a Special Event
Trigger. This is an internal hardware signal generated
in Compare mode to trigger actions by other modules.
The Special Event Trigger is enabled by selecting
the Compare Special Event Trigger mode
(CCP1M3:CCP1M0 = 1011).
For the CCP module, the Special Event Trigger resets
the Timer1 register pair. This allows the CCPR1
registers to serve as a programmable period register
for the Timer1.
The Special Event Trigger for CCP1 can also start an
A/D conversion. In order to do this, the A/D Converter
must already be enabled.
FIGURE 13-2:
COMPARE MODE OPERATION BLOCK DIAGRAM
CCPR1H CCPR1L
Set CCP1IF
Comparator
Compare
Match
TMR1H TMR1L
Special Event Trigger
(Timer1 Reset)
Output
Logic
4
CCP1CON<3:0>
SQ
R
CCP1 pin
TRIS
Output Enable
© 2008 Microchip Technology Inc.
DS39760D-page 125