PIC18F2450_08 Datasheet, PDF (281/324 Pages) Microchip Technology – 28/40/44-Pin, High-Performance, 12 MIPS, Enhanced Flash, USB Microcontrollers with nanoWatt Technology

PIC18F2450/4450
21.3 DC Characteristics: PIC18F2450/4450 (Industrial)
PIC18LF2450/4450 (Industrial) (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
Param
No.
Sym
Characteristic
Min
Max Units
Conditions
VOL Output Low Voltage
D080
I/O Ports (except RC4/RC5 in
USB mode)
—
0.6
V IOL = 8.5 mA, VDD = 4.5V,
-40°C to +85°C
D083
VOH
OSC2/CLKO
(EC, ECIO modes)
Output High Voltage⁽³⁾
—
0.6
V IOL = 1.6 mA, VDD = 4.5V,
-40°C to +85°C
D090
I/O Ports (except RC4/RC5 in
USB mode)
VDD – 0.7
—
V IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
D092
OSC2/CLKO
(EC, ECIO, ECPIO modes)
VDD – 0.7
—
V IOH = -1.3 mA, VDD = 4.5V,
-40°C to +85°C
Capacitive Loading Specs
on Output Pins
D100⁽⁴⁾ COSC2 OSC2 pin
—
15
pF In XT and HS modes
when external clock is
used to drive OSC1
D101 CIO
All I/O pins and OSC2
(in RC mode)
—
50
pF To meet the AC Timing
Specifications
Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PIC^® microcontroller be driven with an external clock while in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: Parameter is characterized but not tested.
© 2008 Microchip Technology Inc.
DS39760D-page 279