PIC18F2450_08 Datasheet, PDF (280/324 Pages) Microchip Technology – 28/40/44-Pin, High-Performance, 12 MIPS, Enhanced Flash, USB Microcontrollers with nanoWatt Technology

PIC18F2450/4450
21.3 DC Characteristics: PIC18F2450/4450 (Industrial)
PIC18LF2450/4450 (Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
Param
No.
Sym
Characteristic
Min
Max Units
Conditions
VIL
Input Low Voltage
I/O Ports (except RC4/RC5 in
USB mode):
D030
with TTL Buffer
VSS
0.15 VDD V VDD < 4.5V
D030A
—
0.8
V 4.5V ≤ VDD ≤ 5.5V
D032
D032A
D033
MCLR
OSC1 and T1OSI
OSC1
VSS
0.2 VDD V
VSS
0.3 VDD V XT, HS, HSPLL modes⁽¹⁾
VSS
0.2 VDD V EC mode⁽¹⁾
VIH Input High Voltage
I/O Ports (except RC4/RC5 in
USB mode):
D040
with TTL Buffer
0.25 VDD + 0.8V VDD
V VDD < 4.5V
D040A
2.0
VDD
V 4.5V ≤ VDD ≤ 5.5V
D042
D042A
D043
IIL
MCLR
OSC1 and T1OSI
OSC1
Input Leakage Current^(2,3)
0.8 VDD
0.7 VDD
0.8 VDD
VDD
V
VDD
V XT, HS, HSPLL modes⁽¹⁾
VDD
V EC mode⁽¹⁾
D060
I/O Ports (except D+ and D-)
—
±200 nA VDD = 5V
—
±50
nA VDD = 3V
D061
MCLR
—
±1
μA Vss ≤ VPIN ≤ VDD
D063
OSC1
—
±1
μA Vss ≤ VPIN ≤ VDD
IPU
Weak Pull-up Current
D070 IPURB PORTB Weak Pull-up Current
50
400
μA VDD = 5V, VPIN = VSS
Note 1:
2:
3:
4:
In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PIC^® microcontroller be driven with an external clock while in RC mode.
The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
Negative current is defined as current sourced by the pin.
Parameter is characterized but not tested.
DS39760D-page 278
© 2008 Microchip Technology Inc.