MV78100 Datasheet, PDF (67/124 Pages) –

Electrical Specifications
DC Electrical Specifications
9.5.2
General 1.8V (CMOS) DC Electrical Specifications
Table 27 is relevant if the following interfaces are configured to operate at 1.8V, according to
Section 7.2, Hardware Reset, on page 51.
„ Device Bus
„ MPP
„ GMII
„ MII
„ RGMII
„ SMI
„ TDM
„ SYSRSTn
„ UART
„ REF_CLK_PT
„ REF_CLK_SSC
„ TCLK_OUT
„ TCLK_IN
Table 28: General 1.8V Interface (CMOS) DC Electrical Specifications
Param eter
Input low level
Input high level
Output low level
Output high level
Input leakage current
Pin capacitance
Sym bol Test Condition
VIL
VIH
VOL
IOL = 2 mA
VOH IOH = -2 mA
IIL
0 < VIN < VDDIO
Cpin
M in
Typ
M ax
Units Notes
-0.3
0.35*VDDIO V
-
0.65*VDDIO
VDDIO+0.3 V
-
-
0.45
V
-
VDDIO-0.45
-
V
-
-10
10
uA 1, 2
5
pF -
Note s :
1. While I/O is in High-Z.
2. This current does not include the current flow ing through the pullup/pulldow n resistor.
Copyright © 2008 Marvell
December 6, 2008, Preliminary
Document Classification: Proprietary Information
MV-S104552-U0 Rev. D
Page 67