MV78100 Datasheet, PDF (66/124 Pages) –

MV78100
Hardware Specifications
9.5
DC Electrical Specifications
Note
See the Pin Description Section for internal pullup/pulldown,
9.5.1
General 3.3V (CMOS) DC Electrical Specifications
Table 27 is relevant for the following interfaces that only operate at 3.3V:
„ SPI
„ JTAG
Table 27 is also relevant if the following interfaces are configured to operate at 3.3V, according to
Section 7.2, Hardware Reset, on page 51.
„ Device Bus
„ MPP
„ RGMII
„ GMII
„ MII
„ SMI
„ TDM
„ SYSRSTn
„ UART
„ REF_CLK_PT
„ TCLK_OUT
„ TCLK_IN
Table 27: General 3.3V Interface (CMOS) DC Electrical Specifications
Param eter
Input low level
Input high level
Output low level
Output high level
Input leakage current
Pin capacitance
Sym bol Test Condition
VIL
VIH
VOL IOL = 2 mA
VOH IOH = -2 mA
IIL 0 < VIN < VDDIO
Cpin
M in
Typ
M ax
Units Notes
-0.3
0.8
V
-
2.0
VDDIO+0.3 V
-
-
0.4
V
-
2.4
-
V
-
-10
10
uA 1, 2
5
pF
-
Note s :
1. While I/O is in High-Z.
2. This current does not include the current flow ing through the pullup/pulldow n resistor.
MV-S104552-U0 Rev. D
Page 66
Document Classification: Proprietary Information
Copyright © 2008 Marvell
December 6, 2008, Preliminary