AC82GL40-SLB95 Datasheet, PDF (29/98 Pages) Intel Corporation – Intel® Celeron® Mobile Processor Dual-Core on 45-nm Process

Electrical Specifications
Table 8 lists the DC specifications for the processor and are valid only while meeting
specifications for junction temperature, clock frequency, and input voltages. The
Highest Frequency Mode (HFM) and Lowest Frequency Mode (LFM) refer to the highest
and lowest core operating frequencies supported on the Genuine Intel Processor. Unless
specified otherwise, all specifications for the processor are at Tjunction =100 ºC. Care
should be taken to read all notes associated with each parameter.
Table 8.
Voltage and Current Specifications for the Ultra Low Voltage Dual-Core 1M
Cache Intel Celeron SFF Genuine Intel Processor
Symbol
Parameter
Min Typ Max Unit
Notes
V_CC
V_CC of the Processor Core
0.8
1.1
V
V_CC,BOOT Default V_CC Voltage for Initial Power Up
—
1.20
—
V
V_CCP
AGTL+ Termination Voltage
1.00 1.05 1.10
V
V_CCA
PLL Supply Voltage
1.425 1.5 1.575 V
I_CCDES
I_CC for Processors Recommended Design Target —
—
18
A
I_CC for processors
A
I_CC
Processor
Frequency
Die Variant
Number
SU2300
1.2GHz
1MB
17.6
A
I_AH,
I_SGNT
I_CC Auto-Halt & Stop-Grant
—
—
6.3
A
I_SLP
I_CC Sleep
5.9
—
—
A
1, 2
2, 8
5
3, 4
3, 4
3, 4
I_DSLP
I_CC Deep Sleep
—
—
5.0
A
3, 4
I_DPRSLP
I_CC Deeper Sleep
—
—
3.2
A
3, 4
dI_CC/DT
V_CC Power Supply Current Slew Rate at
Processor Package Pin
—
—
600 A/µs
7
I_CCA
I_CC for V_CCA Supply
—
—
130 mA
I_CCP
I_CC for V_CCP Supply before V_CC Stable
I_CC for V_CCPSupply after V_CC Stable
—
—
4.5
A
2.5
A
8
9
NOTES:
1.
Each processor is programmed with a maximum valid voltage identification value (VID), which is set at
manufacturing and can not be altered. Individual maximum VID values are calibrated during
manufacturing such that two processors at the same frequency may have different settings within the VID
range. Note that this differs from the VID employed by the processor during a power management event
(ex: Extended Halt State).
2.
The voltage specifications are assumed to be measured across V_CCSENSE and V_SSSENSE pins at socket with a
100-MHz bandwidth oscilloscope, 1.5-pF maximum probe capacitance, and 1-mΩ minimum impedance.
The maximum length of ground wire on the probe should be less than 5 mm. Ensure external noise from
the system is not coupled in the scope probe.
3.
Specified at 100°C Tj.
4.
Specified at nominal V_CC.
Datasheet
29