GS2961 Datasheet, PDF (98/104 Pages) Gennum Corporation – 3Gb/s, HD, SD SDI Receiver, with Integrated Adaptive Cable Equalizer complete with SMPTE Video Processing

5. Application Reference Design
5.1 High Gain Adaptive Cable Equalizers
The GS2961 has an integrated adaptive cable equalizer. In order to extend the cable
length that an equalizer will remain operational at, it is necessary for the equalizer to
have high gain.
A video cable equalizer must provide wide band gain over a range of frequencies in
order to accommodate the range of data rates and signal patterns that are present in a
SMPTE compliant serial video stream.
Small levels of signal or noise present at the input pins of the GS2961 may cause chatter
at the output. In order to prevent this from happening, particular attention must be paid
to board layout.
5.2 PCB Layout
Special attention must be paid to component layout when designing Serial Digital
Interfaces for HDTV. An FR-4 dielectric can be used, however, controlled impedance
transmission lines are required for PCB traces longer than approximately 1cm. Note the
following PCB artwork features used to optimize performance:
• PCB trace width for 3Gb/s rate signals is closely matched to SMT component width
to minimize reflections due to change in trace impedance.
• The PCB ground plane is removed under the GS2961 input components to minimize
parasitic capacitance.
• High speed traces are curved to minimize impedance changes.
GS2961 3Gb/s, HD, SD SDI Receiver, with Integrated
Adaptive Cable Equalizer
Data Sheet
48004 - 2
November 2009
98 of 104