PXD10 Datasheet, PDF (77/130 Pages) Lumins Inc. – 4” Dia.X 6” extruded aluminum step poles

Electrical characteristics
Table 28. I/O input DC electrical characteristics (continued)
Symbol C
Parameter
Conditions¹
Min
I_LKG CC P Input leakage current
—
–1
T_A = -40°C
—
T_A = 25°C
—
C
T_A = 105°C
—
P
T_J = 150°C
—
R_ON CC D Resistance of the analog switch inside the J Supply range
—
pad type²
3.3–5 V
NOTES:
1 _{VDD = 3.3 V  10% / 5.0 V  10%, TA = 40 to 105 °C.}
2 _{Applies to the J pad type only.}
Value
Typ
—
2
2
12
70
—
Unit
Max
1
A
—
nA
—
nA
500 nA
1000 nA
1
k
3.8.3 I/O output DC characteristics
The following tables provide DC characteristics for bidirectional pads:
• Table 29 provides weak pull figures. Both pull-up and pull-down resistances are supported.
• Table 30 provides output driver characteristics for I/O pads when in SLOW configuration.
• Table 31 provides output driver characteristics for I/O pads when in MEDIUM configuration
(applies to both M1 and M2 type pads).
• Table 32 provides output driver characteristics for I/O pads when in FAST configuration.
• Table 33 provides SMD pad characteristics.
Table 29. I/O pull-up/pull-down DC electrical characteristics ¹
Symbol C
Parameter
Conditions²
Value
Unit
Min Typ Max
|I_WPU| CC P Weak pull-up current absolute V_IN = V_IL, V_DD = 5.0V 10% PAD3V5V = 0 10
C ^value
PAD3V5V = 1³ 10
— 150 µA
— 250
P
V_IN = V_IL, V_DD = 3.3V 10% PAD3V5V = 1 10
|I_WPD| CC P Weak pull-down current abso- V_IN = V_IL, V_DD = 5.0V 10% PAD3V5V = 0 10
C ^{lute value}
PAD3V5V = 1 10
— 150
— 150 µA
— 250
P
V_IN = V_IL, V_DD = 3.3V 10% PAD3V5V = 1 10 — 150
NOTES:
1 _{The pull currents are dependent on the HVE settings.}
2 _{VDD = 3.3 V  10% / 5.0 V  10%, TA = 40 to 125 °C, unless otherwise specified.}
3 _{The configuration PAD3V5 = 1 when VDD = 5 V is only a transient configuration during power-up. All pads but}
RESET and Nexus output (MDOx, EVTO, MCKO) are configured in input or in high impedance state.
PXD10 Microcontroller Data Sheet, Rev. 1
Freescale Semiconductor
77