PXD10 Datasheet, PDF (30/130 Pages) Lumins Inc. – 4” Dia.X 6” extruded aluminum step poles

Pinout and signal descriptions
2.3 Pad configuration during reset phases
All pads have a fixed configuration under reset.
During the power-up phase, all pads are forced to tristate.
After power-up phase, all pads are floating with the following exceptions:
• PB[5] (FAB) is pull-down. Without external strong pullup the device starts fetching from flash.
• RESET pad is driven low. This is released only after PHASE2 reset completion.
• Main oscillator pads (EXTAL, XTAL) are tristate.
• Nexus output pads (MDO[n], MCKO, EVTO, MSEO) are forced to output.
• The following pads are pullup:
— PB[6]
— PH[0]
— PH[1]
— PH[3]
— EVTI
2.4 Voltage supply pins
Voltage supply pins are used to provide power to the device. Two dedicated pins are used for 1.2 V
regulator stabilization.
There is a preferred power-up sequence for devices in the PXD10 family. That sequence is described in
the following paragraphs.
Broadly, the supply voltages can be grouped as follows:
• VREG HV supply (V_DDR)
• Generic I/O supply
— V_DDA
— V_{DDE_A}
— V_{DDE_B}
— V_{DDE_C}
— V_{DDE_E}
— V_DDMA
— V_DDMB
— V_DDMC
— V_DDPLL
• LV supply (V_DD12)
The preferred order of ramp up is as follows:
1. Generic I/O supply
PXD10 Microcontroller Data Sheet, Rev. 1
30
Freescale Semiconductor