MA31750 Datasheet, PDF (33/42 Pages) Dynex Semiconductor – High Performance MIL-STD-1750 Microprocessor

Subgroup
1
2
3
7
8A
8B
9
10
11
Definition
Static characteristics specified in Table 36 at +25°C
Static characteristics specified in Table 36 at +125°C
Static characteristics specified in Table 36 at -55°C
Functional characteristics specified in Table 35 at +25°C
Functional characteristics specified in Table 35 at +125°C
Functional characteristics specified in Table 35 at -55°C
Switching characteristics specified in Table 32a at +25°C
Switching characteristics specified in Table 32a at +125°C
Switching characteristics specified in Table 32a at -55°C
Figure 37: Definition of MIL-STD-883, Method 5005 Subgroups
1000
800
600
400
200
0
Input Voltage (V)
Figure 38: Input Characteristic
10. PIN DESCRIPTIONS
A description of each pin function appears in Figure 39.
The acronym is presented first, followed by its function and
description. Timing characteristics of each of the functions are
shown in section 6.
All signals - with the exception of CLK and TCLK are
CMOS compatible, and are protected by an Electrostatic
Discharge (ESD) protection circuit. All output signals are also
TTL compatible. CLK and TCLK are Schmitt inputs.
Throughout this data sheet, active low signals are denoted
by following the signal name with an “N” suffix, e.g.,DSN. If a
signal has a dual function, both function names will be used
separated by a “/”. The function name to the left of the “/” will be
active high while the function to the right will be active low,
again with an “N” suffix, e.g., RD/WN.
All unused inputs should be connected to their inactive
state and should not be allowed to float.
MA31750
33/42