UG534 Datasheet, PDF (56/96 Pages) –

Chapter 1: ML605 Evaluation Board
FPGA_PROG_B Pushbutton SW4 (Active-Low)
This switch grounds the FPGA's PROG_B pin when pressed. This action clears the FPGA.
See the Virtex-6 FPGA Data Sheet for more information on clearing the contents of the
FPGA. [Ref 4]
X-Ref Target - Figure 1-24
VCC2V5
FPGA PROG
FPGA_PROG_B
Pushbutton
1 _P1
P4 ⁴
2 _P2
SW4
P3 ³
Silkscreen:
PROG
UG534_24_073109
Figure 1-24: FPGA PROG_B Pushbutton SW4
SYSACE_RESET_B Pushbutton SW3 (Active-Low)
When the System ACE CF configuration mode pin is high (enabled by closing DIP switch
S1 switch 4), the System ACE CF controller configures the FPGA from the CompactFlash
card when a card is inserted or the SYSACE RESET button is pressed. See 5. System ACE
CF and CompactFlash Connector, page 26 for more details.
X-Ref Target - Figure 1-25
SYSACE_RESET_B
silkscreen:
“SYSACE RESET”
Pushbutton
1 _P1
P4 ⁴
2 _P2
SW3
P3 ³
UG534_25_073109
Figure 1-25: System ACE CF RESET_B Pushbutton SW3
56
www.xilinx.com
ML605 Hardware User Guide
UG534 (v1.8) October 2, 2012