UG534 Datasheet, PDF (15/96 Pages) –

Detailed Description
Table 1-1: ML605 Features (Cont’d)
Number
Feature
Notes
Switches
a. Power On/Off
Slide switch
b. FPGA_PROG_B
18
pushbutton
active-Low
c. System ACE CF Image
Select
4-pole DIP switch (active-High)
d. Mode Switch
6-pole DIP switch (active-High)
19 FMC - HPC connector
Samtec ASP-134486-01
20 FMC - LPC connector
Samtec ASP-134603-01
Power management
a. PMBus controllers
2 x TI UCD9240PFC
b. Voltage regulators
21
c. 12V power input
connector
2 x PTD08A020W, 3 x PTD08A010W
6-pin Molex mini-fit connector
d. 12V power input
connector
4-pin ATX disk type connector
22
System Monitor Interface
connector
2x6 DIP male pin header
23
System ACE Error DS30 LED Jumper on = enable LED
disable jumper J69
Jumper off = disable LED
Schematic
Page
13, 25, 39
39
13
25
25
16 -19
20
35 - 44
35, 40
36-38, 43,
44
39
39
34
13
1. Virtex-6 XC6VLX240T-1FFG1156 FPGA
A Virtex-6 XC6VLX240T-1FFG1156 FPGA is installed on the embedded development
board.
Keep-Out areas and drill holes are defined around the FPGA to support an Ironwood
Electronics SG-BGA-6046 FPGA socket.
References
See the Virtex-6 FPGA Data Sheet. [Ref 4]
Configuration
The ML605 supports configuration in the following modes:
• Slave SelectMAP (using Platform Flash XL with the onboard 47 MHz oscillator)
• Master BPI-Up (using Linear BPI Flash device)
• JTAG (using the included USB-A to Mini-B cable)
• JTAG (using System ACE CF and CompactFlash card)
ML605 Hardware User Guide
www.xilinx.com
15
UG534 (v1.8) October 2, 2012