UG534 Datasheet, PDF (37/96 Pages) –

Detailed Description
References
See the following websites for more Virtex-6 FPGA Integrated Endpoint Block for PCI
Express information:
• http://www.xilinx.com/products/ipcenter/V6_PCI_Express_Block.htm
• http://www.xilinx.com/support/documentation/ipbusinterfacei-o_pci-
express_v6pciexpressendpointblock.htm
In addition, see the PCI Express specifications for more information. [Ref 27]
10. SFP Module Connector
The board contains a small form-factor pluggable (SFP) connector and cage assembly that
accepts SFP modules. The SFP interface is connected to MGT Bank 116 on the FPGA. The
SFP module serial ID interface is connected to the “SFP” IIC bus (see 15. IIC Bus, page 44
for more information). The control and status signals for the SFP module are connected to
jumpers and test points as described in Table 1-9. The SFP module connections are shown
in Table 1-10, page 38.
Table 1-9: SFP Module Control and Status
SFP Control/Status
Signal
Board Connection
Test Point J52
SFP_TX_FAULT
High = Fault
Low = Normal Operation
Jumper J65
SFP_TX_DISABLE
Off = SFP Disabled
On = SFP Enabled
Test Point J53
SFP_MOD_DETECT High = Module Not Present
Low = Module Present
Jumper J54
SFP_RT_SEL
Jumper Pins 1-2 = Full Bandwidth
Jumper Pins 2-3 = Reduced Bandwidth
Test Point J51
SFP_LOS
High = Loss of Receiver Signal
Low = Normal Operation
ML605 Hardware User Guide
www.xilinx.com
37
UG534 (v1.8) October 2, 2012