LM3S5P36 Datasheet, PDF (715/1050 Pages) Texas Instruments – Stellaris® LM3S5P36 Microcontroller

Figure 15-13. Slave Command Sequence
Idle
Stellaris^® LM3S5P36 Microcontroller
Write OWN Slave
Address to
I2CSOAR
Write -------1
to I2CSCSR
Read I2CSCSR
NO _{TREQ bit=1?}
YES
Write data to
I2CSDR
NO _{RREQ bit=1?}
FBR is
also valid ^YES
Read data from
I2CSDR
15.4
Initialization and Configuration
The following example shows how to configure the I²C module to transmit a single byte as a master.
This assumes the system clock is 20 MHz.
1. Enable the I²C clock by writing a value of 0x0000.1000 to the RCGC1 register in the System
Control module (see page 262).
2. Enable the clock to the appropriate GPIO module via the RCGC2 register in the System Control
module (see page 271). To find out which GPIO port to enable, refer to Table 22-5 on page 980.
3. In the GPIO module, enable the appropriate pins for their alternate function using the
GPIOAFSEL register (see page 424). To determine which GPIOs to configure, see Table
22-4 on page 976.
4. Enable the I²C pins for open-drain operation. See page 429.
5. Configure the PMCn fields in the GPIOPCTL register to assign the I²C signals to the appropriate
pins. See page 441 and Table 22-5 on page 980.
6. Initialize the I²C Master by writing the I2CMCR register with a value of 0x0000.0010.
January 21, 2012
715
Texas Instruments-Production Data