E202075_HD404889 Datasheet, PDF (72/202 Pages) Renesas Technology Corp – Low-Voltage AS Microcomputers with On-Chip LCD Circuit

HD404889/HD404899/HD404878/HD404868 Series
D Port
The D port consists of 12 I/O pins (10 I/O pins in the HD404868 Series) that are addressed bit-by-bit.
Ports D₀ to D₃ are source large-current I/O pins, and ports D₄ to D₁₁ (ports D₄ to D₉ in the HD404868
Series) are sink large-current I/O pins.
The D port can be set and reset by the SED and RED instructions or the SEDD and REDD instructions.
Output data is stored in the port data register (PDR) for each pin. The entire D port can be tested by the TD
or TDD instruction.
The D port output buffer is turned on and off by the D port data control registers (DCD0 to DCD2: $030 to
$032). The DCD registers are mapped onto memory addresses (figure 27).
Ports D₀ and D₁ are multiplexed as interrupt input pins INT₀ and INT₁, respectively. Setting as interrupt
pins is performed by bits 0 and 1 (PMR00, PMR01) of port mode register 0 (PMR0: $008) (figure 28).
70