RX113_16 Datasheet, PDF (53/131 Pages) Renesas Technology Corp – 32 MHz, 32-bit RX MCUs, 50 DMIPS, up to 512 Kbytes of flash memory

RX113 Group
5. Electrical Characteristics
5. Electrical Characteristics
5.1 Absolute Maximum Ratings
Table 5.1 Absolute Maximum Ratings
Conditions: VSS = AVSS0 = VREFL0 = VREFL = VSS_USB = 0 V
Item
Power supply voltage
Input voltage
Ports for 5 V tolerant*¹
Ports P40 to P44, P46,
ports P90 to P92,
ports PJ6, PJ7
Symbol
VCC, VCC_USB
V_in
V_in
Value
Unit
–0.3 to +4.6
V
–0.3 to +6.5
V
–0.3 to AVCC0 +0.3
V
Ports other than above
Reference power supply voltage
V_in
VREFH0
–0.3 to VCC +0.3
V
–0.3 to AVCC0 +0.3
V
VREFH
Analog power supply voltage
AVCC0
–0.3 to +4.6
V
Analog input voltage
V_AN
–0.3 to AVCC0 + 0.3
V
(when AN000 to AN007 and AN021 used)
–0.3 to VCC + 0.3
(when AN008 to AN015 used)
LCD voltage
V_L1 voltage
V_L2 voltage
V_L3 voltage
V_L4 voltage
Operating temperature*²
V_L1
–0.3 to +2.8
V
V_L2
–0.3 to +6.5
V_L3
–0.3 to +6.5
V_L4
–0.3 to +6.5
T_opr
–40 to +85
°C
–40 to +105
Storage temperature
T_stg
–55 to +125
°C
Caution: Permanent damage to the MCU may result if absolute maximum ratings are exceeded.
To preclude any malfunctions due to noise interference, insert capacitors of high frequency characteristics between the VCC and
VSS pins, between the AVCC0 and AVSS0 pins, between the VCC_USB and VSS_USB pins, between the VREFH0 and
VREFL0 pins, and between the VREFH and VREFL pins. Place capacitors of about 0.1 μF as close as possible to every power
supply pin and use the shortest and heaviest possible traces. Also, connect capacitors as stabilization capacitance.
Connect the VCL pin to a VSS pin via a 4.7 µF capacitor. The capacitor must be placed close to the pin, refer to section 5.15.1,
Connecting VCL Capacitor and Bypass Capacitors.
Do not input signals or an I/O pull-up power supply to ports other than 5-V tolerant ports while the device is not powered. The
current injection that results from input of such a signal or I/O pull-up may cause malfunction and the abnormal current that
passes in the device at this time may cause degradation of internal elements.
If input voltage (within the specified range from -0.3 to + 6.5V) is applied to 5-V tolerant ports, it will not cause problems such as
damage to the MCU.
Note 1. Ports P16, P17, PA6, and PB0 are 5 V tolerant.
Note 2. The upper limit of operating temperature is 85°C or 105°C, depending on the product. For details, refer to Table 1.3, List of
Products.
R01DS0216EJ0110 Rev.1.10
Mar 31, 2016
Page 53 of 131