M30218 Datasheet, PDF (38/179 Pages) Mitsubishi Electric Semiconductor – M30218 Group

Interrupt
Mitsubishi microcomputers
M30218 Group
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
Time (a) is dependent on the instruction under execution. Thirty cycles is the maximum required for the
DIVX instruction.
Time (b) is as shown in Table DD-5.
Table DD-5. Time required for executing the interrupt sequence
Interrupt vector address Stack pointer (SP) value
16-Bit bust
8-Bit bus
Even
Even
18 cycles (Note 1)
20 cycles (Note 1)
Even
Odd
19 cycles (Note 1)
20 cycles (Note 1)
Odd (Note 2)
Even
19 cycles (Note 1)
20 cycles (Note 1)
Odd (Note 2)
Odd
20 cycles (Note 1)
20 cycles (Note 1)
________
Note 1: Add 2 cycles in the case of a DBC interrupt; add 1 cycle in the case either of an address coincidence
interrupt or of a single-step interrupt.
Note 2: Locate an interrupt vector address in an even address, if possible.
BCLK
Address bus
Data bus
R
W
12
3
4
5
6
7
8
9
10 11 12 13 14 15 16 17 18
Address
0000
Interrupt
information
Indeterminate
Indeterminate
Indeterminate
SP-2
SP-4
vec
vec+2
PC
SP-2
SP-4
vec
vec+2
contents contents contents contents
The indeterminate segment is dependent on the queue buffer.
If the queue buffer is ready to take an instruction, a read cycle occurs.
Figure DD-5. Time required for executing the interrupt sequence
Variation of IPL when Interrupt Request is Accepted
If an interrupt request is accepted, the interrupt priority level of the accepted interrupt is set in the IPL.
If an interrupt request, that does not have an interrupt priority level, is accepted, one of the values shown
in Table DD-6 is set in the IPL.
Table DD-6. Relationship between interrupts without interrupt priority levels and IPL
Interrupt sources without priority levels
Value set in the IPL
Watchdog timer
7
Reset
0
Other
Not changed
37