M16C62N Datasheet, PDF (185/213 Pages) Renesas Technology Corp – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER

Mitsubishi microcomputers
M16C / 62N Group (80-pin)
Appendix Standard Serial I/O Mode 1 (Flash Memory Version) ^{SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER}
Erase All Unlocked Blocks Command
This command erases the content of all blocks. Execute the erase all unlocked blocks command as
explained here following.
(1) Transfer the “A716” command code with the 1st byte.
(2) Transfer the verify command code “D016” with the 2nd byte. With the verify command code, the
erase operation will start and continue for all blocks in the flash memory.
When block erasing ends, the RTS1 (BUSY) signal changes from the “H” to the “L” level. The result of the
erase operation can be known by reading the status register. Each block can be erase-protected with the
lock bit. For more information, see the section on the data protection function.
CLK1
RxD1
(M16C reception data)
TxD1
(M16C transmit data)
RTS1(BUSY)
A716 D016
Figure 1.32.7. Timing for erasing all unlocked blocks
Lock Bit Program Command
This command writes “0” (lock) for the lock bit of the specified block. Execute the lock bit program
command as explained here following.
(1) Transfer the “7716” command code with the 1st byte.
(2) Transfer addresses A8 to A15 and A16 to A23 with the 2nd and 3rd bytes respectively.
(3) Transfer the verify command code “D016” with the 4th byte. With the verify command code, “0” is
written for the lock bit of the specified block. Write the highest address of the specified block for
addresses A8 to A23.
When writing ends, the RTS1 (BUSY) signal changes from the “H” to the “L” level. Lock bit status can
be read with the read lock bit status command. For information on the lock bit function, reset proce-
dure and so on, see the section on the data protection function.
CLK1
RxD1
(M16C reception data)
TxD1
(M16C transmit data)
RTS1(BUSY)
7716
A8 to A16 to
A15
A23
D016
Figure 1.32.8 Timing for the lock bit program
184