M16C62N Datasheet, PDF (174/213 Pages) Renesas Technology Corp – SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER

Mitsubishi microcomputers
M16C / 62N Group (80-pin)
Functions To Inhibit Rewriting Flash Memory Version (Flash Memory Version) ^{SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER}
Functions To Inhibit Rewriting Flash Memory Version
To prevent the contents of the flash memory version from being read out or rewritten easily, the device
incorporates a ROM code protect function for use in parallel I/O mode and an ID code check function for
use in standard serial I/O mode.
ROM code protect function
The ROM code protect function is used to prohibit reading out or modifying the contents of the flash
memory during parallel I/O mode and is set by using the ROM code protect control address register
(0FFFFF16). Figure 1.30.1 shows the ROM code protect control address (0FFFFF16). (This address ex-
ists in the user ROM area.)
If one of the pair of ROM code protect bits is set to 0, ROM code protect is turned on, so that the contents
of the flash memory version are protected against readout and modification.
If both of the two ROM code protect reset bits are set to “00,” ROM code protect is turned off, so that the
contents of the flash memory version can be read out or modified. Once ROM code protect is turned on,
the contents of the ROM code protect reset bits cannot be modified in parallel I/O mode. Use the serial I/
O or some other mode to rewrite the contents of the ROM code protect reset bits.
ROM code protect control address
b7 b6 b5 b4 b3 b2 b1 b0
1 1 11
Symbol
ROMCP
Address
0FFFFF16
When reset
FF16
Bit symbol
Reserved bit
Bit name
ROMCR
ROM code protect reset
bit (Note 2)
ROMCP1 ^{ROM code protect level}
1 set bit (Note 1)
Function
Always set this bit to 1.
b5 b4
0 0: Protect removed
0 1: Protect set bit effective
1 0: Protect set bit effective
1 1: Protect set bit effective
b7 b6
0 0: Protect enabled
0 1: Protect enabled
1 0: Protect enabled
1 1: Protect disabled
Note 1: When ROM code protect is turned on, the on-chip flash memory is protected against
readout or modification in parallel input/output mode.
Note 2: The ROM code protect reset bits can be used to turn off ROM code protect level 1.
However, since these bits cannot be changed in parallel input/output mode, they need to
be rewritten in serial input/output or some other mode.
Figure 1.30.1. ROM code protect control address
173