English
Language : 

N25Q512A13GF840E Datasheet, PDF (44/91 Pages) Micron Technology – Micron Serial NOR Flash Memory 3V, Multiple I/O, 4KB Sector Erase N25Q512A
512Mb, Multiple I/O Serial Flash Memory
READ MEMORY Operations
READ MEMORY Operations
The device supports default reading and writing to an A[MAX:MIN] of A[23:0] (3-byte
address).
Reading and writing to an A[MAX:MIN] of A[31:0] (4-byte address) is also supported. Se-
lection of the 3-byte or 4-byte address range can be enabled in two ways: through the
nonvolatile configuration register or through the ENABLE 4-BYTE ADDRESS MODE/
EXIT 4-BYTE ADDRESS MODE commands. Further details for these settings and com-
mands are in the respective register and command sections of the data sheet.
After any READ command is executed, the device will output data from the selected ad-
dress in the die. After a die boundary is reached, the device will start reading again from
the beginning of the same 256Mb die.
A complete device reading is completed by executing read twice.
3-Byte Address
To execute READ MEMORY commands, S# is driven LOW. The command code is input
on DQn, followed by input on DQn of three address bytes. Each address bit is latched in
during the rising edge of the clock. The addressed byte can be at any location, and the
address automatically increments to the next address after each byte of data is shifted
out; therefore, a die can be read with a single command. The operation is terminated by
driving S# HIGH at any time during data output.
Table 25: Command/Address/Data Lines for READ MEMORY Commands
Note 1 applies to entire table
STR Mode
DTR Mode
Extended SPI Protocol
Supported
Command Input
Address Input
Data Output
Dual SPI Protocol
Supported
Command Input
Address Input
Data Output
Quad SPI Protocol
Supported
Command Input
Address Input
READ
03
–
Yes
DQ0
DQ0
DQ1
No
–
–
–
No
–
–
FAST
READ
0B
0D
Command Name
DUAL
QUAD
DUAL OUTPUT INPUT/OUTPUT QUAD OUTPUT INPUT/OUTPUT
FAST READ FAST READ FAST READ FAST READ
3B
BB
6B
EB
3D
BD
6D
ED
Yes
DQ0
DQ0
DQ1
Yes
DQ0
DQ0
DQ[1:0]
Yes
DQ0
DQ[1:0]
DQ[1:0]
Yes
DQ0
DQ0
DQ[3:0]
Yes
DQ0
DQ[3:0]
DQ[3:0]
Yes
Yes
Yes
No
No
DQ[1:0]
DQ[1:0]
DQ[1:0]
–
–
DQ[1:0]
DQ[1:0]
DQ[1:0]
–
–
DQ[1:0]
DQ[1:0]
DQ[1:0]
–
–
Yes
No
DQ[3:0]
–
DQ[3:0]
–
No
Yes
Yes
–
DQ[3:0]
DQ[3:0]
–
DQ[3:0]
DQ[3:0]
PDF: 09005aef84752721
n25q_512mb_1ce_3V_65nm.pdf - Rev. O 05/13 EN
44
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2011 Micron Technology, Inc. All rights reserved.