PIC24FJ256GA110_10 Datasheet, PDF (244/330 Pages) Microchip Technology – 64/80/100-Pin, 16-Bit, General Purpose Flash Microcontrollers with Peripheral Pin Select

PIC24FJ256GA110 FAMILY
REGISTER 24-1: CTMUCON: CTMU CONTROL REGISTER (CONTINUED)
bit 3-2
bit 1
bit 0
EDG1SEL<1:0>: Edge 1 Source Select bits
11 = CTED1 pin
10 = CTED2 pin
01 = OC1 module
00 = Timer1 module
EDG2STAT: Edge 2 Status bit
1 = Edge 2 event has occurred
0 = Edge 2 event has not occurred
EDG1STAT: Edge 1 Status bit
1 = Edge 1 event has occurred
0 = Edge 1 event has not occurred
Note 1: If TGEN = 1, the CTEDGx inputs and CTPLS outputs must be assigned to available RPn pins before use.
See Section 10.4 “Peripheral Pin Select” for more information.
REGISTER 24-2: CTMUICON: CTMU CURRENT CONTROL REGISTER
R/W-0
ITRIM5
bit 15
R/W-0
ITRIM4
R/W-0
ITRIM3
R/W-0
ITRIM2
R/W-0
ITRIM1
R/W-0
ITRIM0
U-0
U-0
U-0
U-0
U-0
U-0
—
—
—
—
—
—
bit 7
R/W-0
IRNG1
U-0
—
R/W-0
IRNG0
bit 8
U-0
—
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 15-10
bit 9-8
bit 7-0
ITRIM<5:0>: Current Source Trim bits
011111 = Maximum positive change from nominal current
011110
.....
000001 = Minimum positive change from nominal current
000000 = Nominal current output specified by IRNG<1:0>
111111 = Minimum negative change from nominal current
.....
100010
100001 = Maximum negative change from nominal current
IRNG<1:0>: Current Source Range Select bits
11 = 100  Base Current
10 = 10  Base Current
01 = Base current level (0.55 A nominal)
00 = Current source disabled
Unimplemented: Read as ‘0’
DS39905E-page 244
 2010 Microchip Technology Inc.