TC1130 Datasheet, PDF (76/113 Pages) Infineon Technologies AG – 32-Bit Single-Chip Microcontroller

TC1130
Absolute Maximum Rating Targets
Parameter
Symbol Limit Values Unit Notes
min.
max.
Ambient temperature
T_A
-40
Storage temperature
T_ST
-65
Junction temperature
T_J
-40
Voltage at 1.5V power supply V_DDC -0.5
pins with respect to V_SS1)
Voltage at 3.3V power supply V_DDP -0.5
pins with respect to V_SS2)
Voltage on any pin with respect V_IN
-0.5
to V_SS2)
Input current on any pin during I_IN
-10
overload condition
Absolute sum of all input currents ΣI_IN
–
during overload condition
85
150
125
1.7
4.0
4.0
10
|100|
°C under bias
°C –
°C under bias
V–
V–
V–
mA ³⁾
mA ³⁾
CPU & LMB Bus Frequency
f_sys
–
150
MHz –
FPI Bus Frequency
f_FPI
–
100
MHz –
Power dissipation
P_D
–
tbd
W–
1) _{Applicable for VDD and VDDOSC.}
2) _{Applicable for VDDP and VDDOSC3. The maximum voltage difference must not exceed 4.0V in any case (i.e.}
Supply Voltage = 4.0V and Input Voltage = -0.5V is not allowed).
3) _{Restricted life time: TBD}
Note: Stresses above those listed under “Absolute Maximum Ratings” may cause
permanent damage to the device. This is a stress rating only and functional
operation of the device at these or any other conditions above those indicated in
the operational sections of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability.
During absolute maximum rating overload conditions (V_IN > V_DD or V_IN < V_SS) the
voltage on V_DD pins with respect to ground (V_SS) must not exceed the values
defined by the absolute maximum ratings.
Data Sheet
72
V0.3, 2003-09